How do I install ProBEAM Dynamic Strips LED Turn Signals on my motorcycle?

[GiannaMarie]

Installing ProBEAM Dynamic Strips LED Turn Signals (PB-DS-14-BLK) on your motorcycle involves a series of steps. Here's a detailed guide to help you through the process:

1. Begin by removing your motorcycle's existing turn signal assembly. This typically involves unscrewing the securing nuts.
2. Disconnect the wiring connector from the existing turn signal assembly.
3. Remove the mounting studs from the fork using a wrench or socket.
4. Repeat the above steps to remove the turn signal assembly from the opposite side.
5. Next, remove the top T27 Torx bolts from the outer fairing and then remove the windshield.
6. Reinstall the center T27 Torx bolt to keep the fairing secure while you remove the inner fairing bolts.
7. Take out the T27 Torx bolts from both the left and right sides of the inner fairing.
8. Disconnect the connector from the headlamp, and carefully lay the fairing on a flat surface.
9. Connect the male connector of the AW Converter harness into the female connector on your motorcycle's factory turn signal wiring harness.
10. Plug the male plug on the ProBEAM Dynamic Strips harness into the hole in the fork frame and connect it to the female connector of the AW Converter.
11. Attach the ProBEAM Dynamic Strips to the fork frame using the provided button head bolts and washers.
12. Use the provided wire ties to secure the wiring harnesses and converters, ensuring they are protected during the fairing installation.
13. Reinstall the fairing and windshield, following the reverse order of removal, and make sure all bolts are correctly placed.
14. With the ignition off, activate the hazard flashers for 3 minutes. This will sync the BCM with the ProBEAM Dynamic Strips.
15. Finally, test all lighting modes to confirm they are functioning correctly.

If you need further assistance during the installation, Custom Dynamics is available to help. You can reach them at 1 [phone].