Installing your Scylla Electric Robe Warmer requires careful attention to safety and electrical regulations. Here's a step-by-step guide to help you through the process:
-
Safety First: Before you begin, always switch off the electrical power supply to the circuit. Electrical work should be performed by a qualified electrician, ensuring compliance with local and national wiring regulations.
-
Choosing the Right Spot: Carefully select the installation location, ensuring no hidden hazards such as electrical wiring, telephone cables, water pipes, or gas pipes are present behind the wall. Make sure the wall can support the robe warmer's weight, and the power cable can reach a power outlet.
-
Height Matters: For safety, especially around children, mount the robe warmer so the lowest heated rail is at least 600 mm (approximately 2 feet) from the floor.
-
Check Your Kit: Ensure you have all the necessary components, including wall bracket fitting parts like wall plugs, screws, and the Allen key.
-
Installation Steps:
- Remove the cable connection cover plate screws and take off the cover plate.
- Slide the bracket cover up and remove the wall plate grub screws.
- Detach the plastic wall plate from the rail, slide it over the cable, and mark the screw holes. Drill the holes, insert wall plugs, and securely attach the wall bracket to the wall.
- Guide the power supply cable through the cover plate hole into the cable connection leg.
- Slide the rail onto the wall bracket over the O-ring, ensuring it's level using a spirit level. Push the rail against the wall and secure it in place.
- Connect the power feed wires to the robe rail power connector block.
- Secure the rail by tightening the grub screws on both legs.
- Reattach the cable connection cover plate and tighten the screws.
-
Electrical Connection: All electrical connections must be made by a qualified electrician, adhering to local and national electrical installation regulations. Proper protection, like a 30 mA RCD (Residual Current Device), is essential, particularly in bathrooms.
-
Operating Your Warmer: You can turn the robe warmer on and off using the power feed isolation switch. To activate the heater, use the ON/OFF switch on the timer control panel. A 2-4 hour timer function is also available.
-
Cleaning Instructions: To clean your Scylla Electric Robe Warmer, use a soft, damp cloth. Avoid harsh scrubbing or cleaning agents containing acids or corrosive substances.
By following these instructions, you'll be able to enjoy the comfort and convenience of your Scylla Electric Robe Warmer safely and effectively.
