Installing your delta SRV SOHO Serie Servo Voltage Stabilizer correctly is crucial for its safe and efficient operation. Here’s a step-by-step guide:
-
Initial Inspection: Upon receiving your delta SRV SOHO Serie Servo Voltage Stabilizer, carefully examine it for any shipping damage. If you find any, immediately contact the carrier.
-
Customization Verification: Ensure that any specific customizations you requested when ordering the stabilizer have been correctly implemented before you proceed with installation.
-
Handling and Storage: Keep the original packaging for proper handling and storage of the device. Store the delta SRV SOHO Serie Servo Voltage Stabilizer in a dry environment, away from direct sunlight, and within a temperature range of -25°C to +55°C. The relative humidity should be between 20% and 95%.
-
Placement and Ventilation: Place the stabilizer in a well-ventilated area, away from direct sunlight and any heat sources. Maintain a minimum distance of 20 cm around the device to ensure adequate airflow.
-
Connection Procedures: All electrical connections must be performed by authorized service technicians. Proper earthing is essential:
- Earthing: The servo regulator must be earthed. Connect the input earth terminal to a high-quality earth line. Earth the loads via the output earthing terminal.
- Input Connection: Install a bipolar automatic fuse on the main switchboard to connect the servo regulator. Include a residual current relay, setting the protection threshold based on a total of 30 mA and the residual currents of connected loads. Use appropriate cable sections between the switchboard and the stabilizer.
- Output Connection: Use separate fuses and residual current relays for each load connected to the stabilizer. Connect the loads to the output, neutral, and output earthing terminals on the stabilizer's switchboard. Select cable sections based on the current requirements of each load.
-
Starting Up and Switching Off: To start the device, switch all fuses and automations on the switchboard to the "ON" position. To switch off the device, turn the switch and fuses to the "0" position. Following these guidelines will help ensure your delta SRV SOHO Serie Servo Voltage Stabilizer is set up correctly and operates safely, in accordance with the manufacturer's instructions.
