How do I install hard drives into my Synology RS820+ RackStation NAS?

[DeAniyah]

Installing hard drives into your Synology RS820+ RackStation NAS is straightforward. Here's a step-by-step guide:

1. Prepare the Synology RS820+:

   • Power off the NAS unit and disconnect it from the power source.
   • Locate the drive bays on the front of the unit.

2. Prepare the Hard Drives:

   • Ensure you have the correct type of drives (3.5" SATA HDDs or 2.5" SATA SSDs) compatible with the RS820+.

3. Install the Hard Drives:

   • Carefully pull out a drive tray from the NAS.
   • Insert the hard drive into the tray, aligning the connectors properly.
   • Secure the hard drive with the provided screws to keep it in place.
   • Repeat this process for each drive you intend to install.

4. Insert the Drive Trays:

   • Slide each drive tray back into its bay in the NAS unit until it clicks securely.

5. Power On the NAS:

   • Connect the power cable to the RS820+ and turn it on.

6. Initialize the Drives:

   • Follow the Synology DiskStation Manager (DSM) setup instructions to initialize the newly installed drives and configure your storage (RAID, volume, etc.).

7. Verify Drive Installation:

   • Access the DSM interface through a web browser to confirm that the drives are recognized and operating correctly. Check the storage manager for drive health and status.

Following these steps will help you successfully install your drives and get your Synology RS820+ RackStation NAS up and running for data storage and management. For detailed instructions, consult the official Synology user manual or contact Synology support.