Setting up your Timberk TEC.E31X M 1000 Electric Convector is straightforward. Here’s a comprehensive guide:
Installation:
Wall Mounting:
- Unpack the convector and mounting kit.
- Select a wall location, maintaining the required clearances from other objects and the floor (refer to the product manual for specifics).
- Mark the installation height on the wall.
- Drill holes of the correct diameter.
- Insert the provided dowels into the holes and tighten the screws.
- Attach the mounting brackets to the convector.
- Mount the convector onto the wall, ensuring the screws align with the brackets, and secure it firmly.
Attaching Feet:
- Turn the convector upside down.
- Align the support feet with the holes on the bottom of the device.
- Insert the feet with wheels until they click into place.
- Confirm secure attachment and place the convector on a level surface.
Connecting to Power:
- Verify the convector is compatible with a 220V~/50Hz single-phase power supply.
- Confirm the voltage matches the specifications on the appliance.
- Adhere to all electrical safety guidelines during connection.
- Use a grounded outlet rated for at least 10A.
- Keep the plug and socket dry to avoid electrical issues.
Operation:
- The control panel features a dual-button switch for power settings and a thermostat for temperature adjustments.
- Press the buttons to choose between low and high heating power modes.
- Use the thermostat handle to set your desired room temperature.
- To turn off the convector, set the switch buttons to "0" and disconnect it from the power outlet.
Maintenance:
- Regularly clean the exterior of the convector with a soft, damp cloth to remove dust and dirt.
- Avoid using abrasive cleaners or sharp objects.
- Periodically clean the rear of the convector to maintain its efficiency.
By following these steps, you will be able to properly set up and use your Timberk TEC.E31X M 1000 Electric Convector.
