How do I install an Acuity Brands HNLS11 Night or Step Light?

[LeElliot]

Installing the Acuity Brands HNLS11 Night or Step Light involves several key steps. First, the HNLS11 is designed to fit a standard switch box that's flush with the wall. Make sure the box is at least 3-1/2 inches deep; the Steel City “CX” series is a good choice. Next, consult the wiring diagrams in the instruction manual to connect the wires correctly. Connect the power supply wires to the driver input wires, following the diagram's instructions. After that, remove and discard the nuts holding the screws on the LED unit and faceplate. Do not separate the LED unit from the faceplate. Apply silicone sealant to the gasket on the back of the faceplate to create a good seal. Place the LED unit into the box, aligning the holes in the faceplate with those in the box. Then, use screws to secure the fixture to the switch box, threading them through both the faceplate and the LED unit. Finally, ensure the holes in the faceplate align with those in the LED unit and secure everything with screws. Always refer to the Acuity Brands HNLS11 manual for detailed instructions, or reach out to Acuity Brands Lighting, Inc. for assistance if needed.