To install the Synapse DIM10-087-06 Controller in your LED fixture, follow these steps for a safe and successful setup: First, and most importantly, always turn off the power at the circuit breaker or fuse box before beginning any installation work. Double-check that the power is off to avoid electrical hazards. Next, mount the DIM10-087-06 Controller using a #4 screw and standoff, securing it inside your LED fixture. If your model uses an external antenna with a u.FL connector for RF connectivity to the SNAP mesh network, ensure the antenna is correctly positioned for optimal wireless signal strength, free from obstructions within the specified range. If you're incorporating sensors, connect them to the controller according to the manual's instructions, ensuring proper connections for sensor power, common, and control wires. For power, connect the 5-24VDC Aux output from your LED driver to the DIM10-087-06 Controller, and also connect the Aux ground from the LED driver to the controller. When connecting the dimming circuit, refer to the manual for your specific LED driver type, and connect the DIM- and DIM+ wires from the LED driver to the corresponding outputs on the DIM10-087-06 Controller. After all connections are made, cap any unused wires. Now, switch the power back on. Your fixture should illuminate as expected. Finally, be sure to review and adhere to all regulatory guidelines and certifications detailed in the manual, particularly regarding RF exposure and FCC compliance. Following these steps and prioritizing safety will help you install your Synapse DIM10-087-06 Controller correctly, ensuring functionality and peace of mind.
