Installing a King Electric KCV Series Cove Heater involves several important steps to ensure safety and optimal performance. First, verify that your electrical power supply matches the heater's voltage requirements (either 120V or 240V). Always prioritize safety by turning off the power at the circuit breaker or fuse box before beginning any work. Lock or tag the circuit breaker to prevent accidental power restoration. Next, prepare for mounting. Do not recess the cove heater. Ensure all wiring complies with local codes and that the unit is properly grounded. The heater's voltage rating must match the supply load. Avoid installing the heater on vinyl wall coverings.
Here's a step-by-step installation guide:
- Remove the heater from its packaging and separate the aluminum heating panel from the back support frame.
- Remove the knockout from the junction box for the electrical supply connection.
- Secure the back support frame to the wall using appropriate fasteners.
- Hang the aluminum heating panel from the top lip of both junction boxes to support it while wiring.
- Connect the supply cable's grounding wire to the green wire pigtail inside the wiring compartment.
- Follow the wiring diagram to connect the power supply to the heater using approved wire nuts.
- Connect the white and black element wires together in the opposite junction box.
- Carefully press the electrical wires into the junction box, avoiding any pinching.
- Install the end caps by pushing the bottom edge of the aluminum heating panel towards the back panel and gently tightening the screws.
Important notes: The heater can be wired from either side, but connect the power wires on only one side. Avoid overtightening the end cap screws to accommodate the aluminum heating panel's expansion and contraction during operation. By following these guidelines, you can safely and effectively install your King Electric KCV Series Cove Heater.
