Mounting your VYNCO INSV0137 2S1IP 2S2IP Standard Switches 250V correctly is crucial for both safety and functionality. Here's a step-by-step guide based on the provided instructions:
- Mounting Orientation: Always mount the switch vertically. Horizontal mounting is not recommended.
- Surface Preparation: Ensure the wall surface is smooth and flat. The hole cut should not be larger than the switch sub-plate seal perimeter.
- Remove Protective Caps: Use side cutters to carefully remove the cap bungs from the sub-plate seal. Keep these for later use.
- Wiring: Connect the wires according to the AS/NZS 3000 Wiring Rules. Proper wiring is essential for safety.
- Securing the Switch: Screw the switch to the wall, tightening each screw to a torque of 1.3Nm. This applies whether mounting to a flush box or a solid wall. Piercing the seal flange is acceptable and recommended for solid wall installations.
- Final Steps: Place the seal bungs back into the flush box mounting holes. Finally, securely attach the cover plate. Following these steps will help you install your VYNCO INSV0137 2S1IP 2S2IP Standard Switches 250V correctly.