Properly setting up the drain line for your ABESTORM Guardian SN90 Dehumidifier is essential for optimal performance. Follow these steps to ensure efficient water removal:
Step 1: Preparation
Place your ABESTORM Guardian SN90 on a level surface. Make sure the dehumidifier remains upright. Allow at least two hours before powering on the unit after placement.
Step 2: Drain Line Connection
Route the drain line to a suitable external drain. The drain line needs to slope downwards without any bends or obstructions.
Recommended PVC Drain Setup:
- Cut a 6-inch piece of 3/4" outer diameter (OD) PVC pipe.
- Insert this PVC pipe into a 3/4" elbow fitting, then connect it to a length of 3/4" OD PVC pipe for drainage. Keep this drain pipe as short as possible.
- Insert the open end of the drain tubing into the 3/4" pipe, ensuring it doesn't go into the elbow.
- Maintain a downward slope of at least 1 inch for every 10 feet of the drain line to ensure proper water flow.
- Support the PVC tubing to maintain the consistent downward slope.
- Always test the drain line connection after installation to verify it is functioning as expected.
Step 3: Power Connection
Plug the ABESTORM Guardian SN90 Dehumidifier into a 15-amp grounded electrical outlet. Ensure the power supply meets the unit's requirements.
By following these steps, you will ensure your ABESTORM Guardian SN90 Dehumidifier functions effectively. Consult the user manual for additional troubleshooting support if you encounter any difficulties.
