To manage the temperature on your SILVERCREST SHL 2000 A1 Fan Heater, follow these steps: First, ensure the heating level switch, labeled "2" in the manual, is set to "0" to power off the device. Next, plug the heater into a grounded socket protected by a residual current device with overload protection. Then, activate the heater by turning the temperature regulator, labeled "4" in the manual, clockwise until you hear a click. After that, set the heating level switch to your desired setting. You have three options: "Fan" for fan-only operation, "Heating level 1" for 1000 W of heating power, and "Heating level 2" for 2000 W of heating power. The control light, labeled "3" in the manual, will illuminate, confirming the device is on. To fine-tune the temperature, rotate the temperature regulator fully clockwise. If the desired warmth isn't reached, rotate the regulator counter-clockwise until you hear a distinct click. The control light will turn off, and the built-in thermostat will automatically adjust the heating based on your set temperature. Remember, when the thermostat is at its lowest ("MIN") setting, the heater is completely off. To switch off the device, first set the heating level switch to the "Fan" position and allow 30 seconds for the heating elements to cool. Finally, set the heating level switch to "0" and unplug the SILVERCREST SHL 2000 A1 Fan Heater from the power outlet. For more detailed safety information and instructions, consult the SILVERCREST SHL 2000 A1 Fan Heater Instruction Manual.
