How do I connect WIFI to my Champion 102007 Automatic Transfer Switch with Axis Controller Module for remote monitoring?

[VanStephanie]

To connect your Champion 102007 Automatic Transfer Switch with Axis Controller Module to WIFI for remote monitoring and control, follow these steps:

1. Get Ready: Use a device with WIFI capabilities such as a laptop, smartphone, or tablet. Make sure you are near your ATS.
2. Find the Network: On your device, search for available WIFI networks. Look for a network named "Champion XXXX," where "XXXX" matches the last four digits of the serial number found on the control board of your Champion ATS.
3. Connect and Enter the Password: The password for the WIFI network is located on a decal on the dead front of the ATS. Enter this password to connect to the Champion network.
4. Access the Settings Page: Once connected, open a web browser on your device. The Champion Axis Controller Home Standby Generator Settings Page should load automatically. If it doesn't, refresh the browser or try entering anything.com in the address bar; the ATS should redirect you to the settings page.
5. Set the Date and Time: On the settings page, set the current date and time using the dropdown menus, or select the "USE THIS DEVICE'S DATE & TIME" button. Then, confirm and save your settings.
6. Set Exercise Schedule: Configure your Home Standby Generator's exercise frequency and schedule. Then, save these settings.
7. Network Settings: The wireless network settings typically do not need to be changed; the default values are usually correct.
8. Final Steps: After setting the date, time, and exercise schedule, you can close your browser and disconnect from the Champion WIFI network.

Troubleshooting: If the Champion Axis Controller Home Standby Generator Settings Page does not load and your device remains connected to the internet, try these steps:

• Turn off mobile data on your device, if applicable.
• Ensure your device is not connected to any other WIFI networks.
• Wait two minutes and try accessing the settings page through your web browser again.

Following these steps should successfully connect your Champion 102007 Automatic Transfer Switch with Axis Controller Module to WIFI, enabling remote monitoring and control.