To connect your transmitter to the receiver in your EMX WEL-200 Wireless Edge Link system, follow these steps: First, mount the transmitter close to your edge sensor using the provided hardware, ensuring the sealing nut faces downwards to prevent moisture from entering. Next, connect the resistor-equipped edge sensor wires to the transmitter terminal block. Ensure your edge sensor provides a resistance between 4K and 12K ohms. Then, insert two AA lithium batteries into the transmitter; the LED on the transmitter should blink quickly, twice every two seconds. Initiate the pairing by pressing and holding the connection button on the transmitter for 1-2 seconds until the LED stops its rapid flashing. A successful connection is indicated by the LED flashing once every four seconds. If the transmitter fails to connect, it will blink fast, twice every two seconds; in this case, repeat the pairing process. To test the connection, without activating the edge sensor, check the channel LEDs on the receiver; they should be off for any channel linked to a transmitter. Activate the edge sensor you are testing. The corresponding channel LED on the receiver should illuminate, and the transmitter's LED should flash twice per second while the edge sensor is active. To connect additional transmitters, repeat these steps. Remember, never connect more than one edge sensor to a single transmitter. If you have any difficulties, consult the troubleshooting section of your manual or reach out to EMX Industries, Inc.'s tech support.
