Connecting your AC-AEX-RC-HUB Audio Centralizer is straightforward. Here's how to get your audio system set up:
- Connecting Audio Sources: Link your audio source devices (like DVD players or gaming consoles) to the AC-AEX-RC-HUB's audio inputs. You can use AEX Audio, RCA, or TOSLINK (optical) inputs depending on the output type of your source devices.
- Connecting Audio Outputs: Connect your audio output devices (such as amplifiers or speakers) to the audio outputs on the AC-AEX-RC-HUB. Choose either the RCA or TOSLINK (optical) outputs based on your output device's compatibility and your preferred audio signal type.
- Powering Up: Plug the AC-AEX-RC-HUB's power port into a power source using the included power cable.
- RS-232 Control (Optional): If you plan to use RS-232 control, connect the RS-232 control port on the rear panel to a computer or a third-party control system. This requires a 3-pin terminal block connector to DB9. Configure serial communications with a Baud rate of 57600, no parity, 8 data bits, 1 stop bit, and no handshaking.
- IP Control (Optional): For IP control, connect the IP control port on the rear panel to your LAN, router, or third-party control system using an 8-pin RJ-45 female connector.
After making these connections, access the AC-AEX-RC-HUB's Web UI through a web browser for configuration and control. The user manual provides detailed information on navigating the Web UI. Always refer to the user manual for safety precautions during installation and operation of your AC-AEX-RC-HUB.
