How do I connect my Sync EVT77G EV Charger to my home Wi-Fi network to enable smart charging features?

[SanEmilia]

Connecting your Sync EVT77G EV Charger to your home network unlocks its smart charging capabilities. Here's how to set it up:

1. Get the App: Download the BG EV Charging app. You can find it through the Installer Portal on the syncev.co.uk website or by scanning the QR codes provided.
2. Enable Bluetooth: Make sure Bluetooth is turned on your device and then open the BG_EV_Charging App.
3. Enter Charger Details: Select your Charger ID Code, which you can find on the charger's identification label. Then, enter the default password: 12345678.
4. Choose Your Connection Method: You have three options: Wi-Fi, 4G, or LAN. Only one can be active. If you select Wi-Fi:
   • Choose your Wi-Fi network (SSID) from the list.
   • Enter your Wi-Fi password. For LAN:
   • Ensure "LAN DHCP" is enabled. For 4G:
   • This is typically pre-configured.
5. Set Server URL: Select the server URL that matches your charging needs: 'Home Charge' for home use or 'Commercial' for other applications.
6. Adjust Output Current: If the maximum output current supported by your home's electrical setup is less than 32A, adjust the setting accordingly.
7. Select Charge Mode: Choose your preferred charge mode:
   • 'APP': For smart charging using the consumer app.
   • 'Plug and Charge': For immediate, non-smart charging.
   • 'RFID': If you are using RFID authorization.
8. Configure Dynamic Load Management (If Required): If you need dynamic load management, enable Power Distribution and set the sampling method to CT.
9. Set Maximum Current Limit: Set the Maximum Current Limit to match or be less than your main fuse rating to ensure proper load balancing.
10. Apply Settings: Press 'Set' to save your settings. The charger should beep to confirm.
11. Verify Connection: Within two minutes, the indicator light on the charger should turn from yellow to blue, indicating a successful network connection. If it stays yellow, try power cycling the charger and double-checking your settings.
12. Troubleshooting: If you can't connect to the network but need to use the charger, switch the Charge Mode to 'Plug and Charge' and press 'SET' again.

For any further assistance, you can contact Sync EV support at [e-mail].