To connect your ECOVACS DEEBOT N8 High Performance vacuum to your Wi-Fi network and enable control through the ECOVACS HOME app, follow these steps: First, ensure your DEEBOT is fully charged and the power switch is turned on. Next, check that the Wi-Fi status light on the DEEBOT is slowly flashing, indicating it's ready for setup. Temporarily disable cellular data on your mobile phone; you can re-enable it after the setup. It's important to verify your Wi-Fi network meets specific requirements for successful connection. Your network should be a 2.4GHz or a 2.4/5 GHz mixed network. Your router must support the 802.11b/g/n standards and IPv4 protocol. Ensure you are not using a VPN or Proxy Server, and your network is not hidden. For security, use WPA and WPA2 with TKIP, PSK, or AES/CCMP encryption; avoid WEP and EAP. Also, use Wi-Fi channels 1-11 in North America and channels 1-13 outside North America. If you are using a network extender or repeater, make sure the network name (SSID) and password match your primary network. After confirming these requirements, use the ECOVACS HOME app on your mobile phone to proceed with the Wi-Fi setup process. If you experience any issues, consult the Troubleshooting > Wi-Fi Connection section in the user manual for further guidance. By following these steps, you will be able to successfully connect your ECOVACS DEEBOT N8 High Performance vacuum to your Wi-Fi, allowing you to control it conveniently through the app.
