Setting up your Bowers & Wilkins A7 Hi-Fi Wireless Music System on your home Wi-Fi network is straightforward. Here's a step-by-step guide:
- Begin by disconnecting all cables from your A7.
- Connect an Ethernet cable from the Ethernet socket on the back of the A7 to an Ethernet port on your computer.
- Plug the power cable into your A7 and connect it to a power outlet. The A7 will power on, and the indicator light will pulse red.
- Wait until the A7 indicator light starts flashing yellow.
- Press and hold the "+" volume button on the A7 for approximately 4 seconds. The indicator light will turn solid purple once the wired network connection is established.
- Open a web browser on your computer and enter the A7's default network address: http://169.254.1.1. Press "Enter" to access the A7 setup page.
- On the setup page, you can optionally change the A7's name. Enter a new name if desired.
- Select your home network name from the drop-down list and enter your Wi-Fi password in the corresponding field. Ensure the password is entered correctly.
- Click the "Apply" button and then close the A7 setup page.
- Disconnect the Ethernet cable from your A7.
- The A7 indicator light will turn solid purple once the wireless network connection is successfully established. This process might take up to 3 minutes.
If your Bowers & Wilkins A7 has trouble connecting to your Wi-Fi network, double-check that you entered the correct password. If needed, you can perform a factory reset by pressing and holding the reset button on the rear panel of the A7 for 2 seconds. Refer to your A7's manual for detailed instructions on factory reset procedures.
Once connected to your Wi-Fi, you can stream audio. For example, configure iTunes to use your A7 as an output device. Select the A7 as the output option within the AirPlay menu in iTunes. Your music will then play wirelessly through your Bowers & Wilkins A7. For additional support, visit the Bowers & Wilkins support section on their website or consult the user manual.
