How do I configure the binary address of the ALCN-792M/ALCN-792MISO Quad Loop Adder Module using DIP switches for my fire alarm system?

[DelJulia]

To set the binary address of your ALCN-792M/ALCN-792MISO Quad Loop Adder Module, follow these steps: First, locate the DIP switches, labeled SW1-1 to SW1-8, on the module. These switches control the binary address. Each switch represents a binary digit. An "ON" position activates the digit and an "OFF" position deactivates it. Consult the DIP switch settings table in the module's manual. This table provides the specific switch configurations for each address. For instance, to assign address "2", set SW1-1 to "OFF", SW1-2 to "ON", and SW1-3 through SW1-8 to "OFF". Always double-check your DIP switch settings to confirm the correct binary address has been assigned. Finally, complete the adder module installation and wiring, adhering to the guidelines in your Network Fire Alarm Manual. Correctly configuring the binary address is crucial for the proper function of your ALCN-792M/ALCN-792MISO Quad Loop Adder Module within your fire alarm system.