Configuring the address on your Potter PAD100-6DB Addressable Detector is straightforward. The address is set using the dip switches located on the device. Here's a step-by-step guide:
- Locate the Dip Switches: Find the seven-position dip switch on your PAD100-6DB.
- Power Off: Before making any adjustments, ensure the detector is powered off.
- Adjust the Switches: Use a small tool, like a screwdriver, to carefully adjust the dip switches.
- Set the Address: Each PAD device can be assigned an address from 1 to 127. Flip the dip switches to the correct positions to set your desired address.
- Consult the Manual: Refer to the Potter PAD100-6DB manual for the exact dip switch configuration corresponding to your desired address. The manual provides the specific switch settings for each address number.
- Power On: Once the dip switches are set, power on the detector.
- Verify the Address: Confirm the address is correctly set. This can be done by checking the system's configuration or the device's response.
By following these steps and consulting the manual for address-specific configurations, you can successfully set the address for your Potter PAD100-6DB Addressable Detector.