Charging the LiPo battery for your AMEWI 22621 Hyper GO Brushed 4WD is straightforward. Here's a step-by-step guide:
- Battery Installation: Begin by unlocking the battery compartment on your Hyper GO Brushed 4WD. Open the cover, connect the receiver plug to the battery, and carefully place the battery into the compartment, ensuring it's securely in place. Close the cover and lock it.
- Charging Setup: Your battery is a 7.4V 1050mAh 25C LiPo. For charging, you'll need a USB charging adapter (not included) with a 5V 2A output. The approximate charging time with this setup is around 120 minutes.
- Charging Indication: While charging, the green LED on the USB charging cable will blink. When the battery is fully charged, this LED will remain lit continuously.
- Important Safety Notes: Always disconnect the battery from the charging cable immediately after charging is complete to prevent overcharging. Using a power supply unit with the recommended 5V 2A output is advised; charging times may vary with different power supplies. Following these instructions will help you safely charge your AMEWI 22621 Hyper GO Brushed 4WD's LiPo battery.