To change the user code on your Roger Technology H85/TDS Keypad Selector, follow these steps:
-
Storing a New User Code:
- Enter the existing user code to access the programming mode.
- Enter 0000 (the red LR LED will illuminate).
- Enter your new user code (e.g., 12345) followed by ##.
- If successful, the green LV LED will light up for 2 seconds, and the buzzer will sound.
-
Activating the User Code:
- Enter the stored user code (e.g., 12345) followed by an asterisk (*).
- If the code is in memory, the green LV LED on the keypad will light up.
- Press and hold the enabled key/channel associated with the user code. For example, if channel B is enabled, enter: 12345*B.
-
Deleting a User Code:
- Identify the user code to be deleted (e.g., 12345).
- Enter ##12345*.
- If successful, the red LR LED will blink and then remain steady-on.
-
Changing the Password:
- To change the password from the default (0000) to a new code (e.g., 12345):
- Enter **0000# (the red LR LED will illuminate).
- Enter the new password (e.g., 12345) followed by ##.
-
Resetting the Password to Factory Setting:
- If the password is lost, it can be reset to the factory default (0000) using a known user code:
- Enter **12345# (the red LR LED will illuminate).
- Enter 0000# to reset the password.
Always consult the Roger Technology H85/TDS Keypad Selector manual for detailed instructions and safety precautions. If you have any programming issues, see the error alerts section in the manual for troubleshooting tips.
