How do I adjust the height and position of my GIMA M34057EN Full Automatic Stretcher?

[DavidFitz]

Adjusting the height and position of your GIMA M34057EN Full Automatic Stretcher is straightforward. Here's a guide:

1. Height Adjustment: The stretcher offers 4 height settings, spanning from 70 cm to 93 cm. To change the height, grasp the handles located on each side of the stretcher. Pull both handles simultaneously to elevate or lower the stretcher to your preferred height.

2. Reclining Angles: The stretcher allows for both forward and backward tilting. It can lean forward up to 11 degrees and recline backward up to 25 degrees. To adjust the angle, make sure the stretcher is stable, and then use the adjustment handles to tilt it as needed.

3. IV Stand Height: To modify the height of the IV stand, lift the pole and push it forward to secure it. To lower it, reverse this step. For finer adjustments, rotate the pole counter-clockwise to release the nut, then extend the pole to your desired height.

4. Lathe Bed Adjustment: The stretcher's lathe bed has handles on both sides that allow you to adjust its position to 4 different levels, and to fold it back and forth. Use the handles to position the bed as needed. You can also adjust the height of the lathe bed using these side handles simultaneously.

By following these steps, you can easily customize your GIMA M34057EN Full Automatic Stretcher for optimal patient comfort and care.