Changing the frequency and power settings on the Speedy Bee TX800 FPV Video Transmitter is straightforward. Here's a step-by-step guide:
-
Frequency and Band Selection:
- Short press the button to cycle through channels CH1 through CH8.
- Long press the button for 2 seconds to enter BAND mode. Short press again to switch between bands 1 through 6.
-
Power Mode Selection:
- Long press the button for 5 seconds to enter POWER mode. Short press to cycle through power levels: 25mW, 200mW, 400mW, and 800mW.
-
Unlock/Lock Settings:
- Long press the button for 10 seconds to unlock or lock the settings.
-
IRC Tramp Protocol Support:
- The TX800 supports the IRC TRAMP protocol, allowing you to adjust transmission parameters like frequency and power via your remote control. If your flight controller supports Bluetooth or WiFi, you can also use the SpeedyBee App.
-
BetaFlight Firmware Requirement:
- If you're using BetaFlight firmware (version 4.1.0 or higher), you'll need to upload a VTX table to your flight controller before using the remote control to adjust settings.
-
Frequency Table:
- Refer to the frequency table in the manual to match the channel to the appropriate band (Band A, Band B, Band E, Airwave, Race Band) for your setup.
-
Orange Channel Note:
- The orange channel is disabled when the settings are locked.
By following these steps, you can easily configure your Speedy Bee TX800 FPV Video Transmitter. Always consult the Speedy Bee TX800 manual for the most detailed information and specific instructions related to your particular setup.
