How do I add the ZWAVE TechniSat Series Switch to my Z-Wave network?

[Keira]

Adding the ZWAVE TechniSat Series Switch to your Z-Wave network is straightforward. Here's how: First, ensure your primary Z-Wave controller is in inclusion mode (also known as adding mode). Then, install the TechniSat Series Switch in its desired location, making sure it's disconnected from the power supply during installation. After wiring and power connections are complete, switch the fuse back on. Next, activate the SmartStart function on your primary Z-Wave controller, following the specific steps for your controller to add a device. Alternatively, you can manually set up the switch: put your primary Z-Wave controller into inclusion mode and follow its operating instructions. Now, quickly press the upper push-button on the TechniSat Series Switch (T1) three times within one second. The LED on the TechniSat Series Switch will turn red while it's connecting to the network. If the addition is successful, the LED will shine green for five seconds. Once integrated, you can control the TechniSat Series Switch and access its features through your Z-Wave controller or other Z-Wave-certified devices within your network. Always consult the TechniSat Series Switch's instruction manual for detailed, device-specific instructions, as procedures can vary slightly depending on your Z-Wave controller model.