How do I activate the timer on my GiveU HWT13001-S2 LED pillar candles?

[StJade]

Setting the timer on your GiveU HWT13001-S2 LED Pillar Plastic Flickering Candles is straightforward. Here's how:

Using the Candle's Power Switch:

1. Ensure the candle is on by sliding the power switch on the bottom to either the "4 hour" or "8 hour" position.
2. To activate the timer, slide the power switch to the "4 / 8 TIMER" position. The candle will then stay lit for either 4 or 8 hours, depending on the switch position, and then automatically turn off for 20 or 16 hours, respectively. This cycle will repeat daily.
3. To reset the timer, turn the candle off using the "OFF" position, and then switch it back to the "4 / 8 TIMER" mode at the desired start time.

Using the Remote Control (if applicable):

1. Turn the candle on using the power switch on the bottom, selecting either the 4-hour or 8-hour setting.
2. If you haven't already, remove the battery insulation sheet from the back of the remote control.
3. When the candle is ON, press the timer button on the remote control (2H, 4H, 6H, or 8H) corresponding to your desired "on" time. The candle will then remain lit for the chosen duration and automatically turn back on at the same time each day.

For optimal performance, replace batteries periodically and remove them if you don't plan to use the candles for extended periods. For more detailed instructions, please consult the GiveU HWT13001-S2 LED Pillar Plastic Flickering Candles User Manual.