
Activating your Lumena Panama Professional Solar Bollard Light is simple. First, find the waterproof rubber bung located just below the polycarbonate lens, aligned with the Lumena logo. Remove the bung to reveal the red on/off button. Next, using a small, flathead screwdriver or similar tool, gently press the on button inwards until you hear a click, allowing it to partially pop back out. This indicates the bollard is now in the ON position. Finally, replace the waterproof rubber bung to safeguard the button from moisture and dust. Please be aware that there may be a 2-5 second delay before the light illuminates after you turn it on. During daylight, the light will turn off within a few seconds, while in darkness, it will remain on, operating according to its pre-set time-controlled cycle. Remember, the solar bollard will only charge when it is switched to the ON position.


