To transfer a CFIG or Log File from your Simplex 4100U Fire Alarm Control Panel to your PC for review or backup, use the Simplex 4100U PC Programmer software, following these steps:
- Launch the PC Programmer: Begin by opening the PC Programmer software on your computer.
- Access the Upload Function: Navigate within the software to the upload section, where file transfer options are located.
- Configure Serial Communication Settings: Ensure the serial communication parameters are correctly set. This involves matching the baud rate, data bits, parity, stop bits, and flow control settings between your PC and the Simplex 4100U panel. These settings are crucial for a successful connection.
- Connect the Serial Cable: Establish a physical connection between your PC and the Simplex 4100U panel using a compatible serial cable. Make sure the cable is securely connected at both ends.
- Initiate Upload on PC: Start the upload process within the PC Programmer software. Follow the on-screen prompts to begin transferring the CFIG or Log File from the panel to your computer.
- Unbuild the CFIG File: After the upload is complete, unbuild the CFIG file to create a .SDB file. This .SDB file is then available for saving on your PC, allowing for detailed analysis and secure backup of your system's data. For specific settings or configurations, always refer to the detailed instructions in the Simplex 4100U Fire Alarm Control Panel manual.
