How can I set up my iRoom iO iTop OnWall docking station for my iPad?

[Whitney]

Setting up your iRoom iO iTop OnWall docking station for your iPad is straightforward. Here’s a step-by-step guide:

1. Backbox Installation: Always begin by installing the included Backbox. Using the device without it may void your warranty. Detailed instructions are in the "Backbox installation manual".
2. Cable Connections: Connect your network cable and, if needed, a power cable to the connectors on the mainboard of the back panel. The power cable is only required if you're using 110 - 240 V AC power.
3. Power Options: You have two power choices. You can connect 110-240V AC wires using the color-coded terminals, or you can use PoE+ (IEEE 802.3at) through a switch or injector.
4. Docking Station Assembly: Attach the back panel to the Backbox using the screws provided. Then, connect the ribbon charging cable to the circuit board, aligning the markers carefully. Secure the front panel to the rear panel with screws and magnets.
5. Keypad & Power: Feed the keypad cable through the opening in the front panel. Attach the keypad bezel. Connect the power source to start up the docking station.
6. Download the App: Download the free "iRoom's iDock" app from the App Store on your iPad.
7. Dock Your iPad: Place your iPad into the iRoom iO iTop OnWall docking station.
8. App Configuration: Open the "iRoom's iDock" app on your iPad and follow the on-screen prompts to configure the docking station.
9. Verify Status: Check the app to confirm that the status shows "online", indicating a successful connection.
10. Customize Icons: To change the icons displayed, disconnect the cable from the keypad bezel, power cycle the docking station, and then reconnect the cable.

By following these steps, you'll have your iRoom iO iTop OnWall docking station ready for use with your iPad. Refer to the user manual for additional details and troubleshooting tips.