Programming the buttons on your Cell2 SW830 Control Panel and Power Module allows you to customize their functionality. Here's how, based on the instruction manual:
-
Setting ON/OFF or Momentary Button Behavior: To configure a button as either an ON/OFF switch or for momentary activation, follow these steps:
- Enter PROGRAMMING MODE by pressing and holding buttons B1 and B4 for 3 seconds.
- Within PROGRAMMING MODE, toggle the desired button (B1-B7) to your desired setting:
- OFF setting configures the button as an ON/OFF switch (this is the default setting).
- ON setting configures the button for momentary activation.
- Exit PROGRAMMING MODE by pressing and holding buttons B1 and B4 again for 3 seconds.
-
European Siren Interlock Configuration: Buttons B5 and B6 can be set up so that B5 turns B6 OFF when deactivated, and B6 turns B5 ON when activated. Refer to your manual for specific configuration steps.
-
Button Mapping Setup: Button B7 can be configured to be activated and deactivated by Button B5. The manual provides the exact instructions to set up this button mapping.
-
LED Signal Display Mode Change: You can change how the 10-LED Signal Display functions. It can show either the Lightbar flash signal or the directional/warning advisor flash signal. Consult the manual for detailed instructions on changing the display mode. By following these programming instructions, you can tailor the Cell2 SW830 Control Panel and Power Module's buttons to your exact needs.
