How can I mount my Fat Cat 727 Electronic Dartboard?

[LeAaliyah]

Mounting your Fat Cat 727 Electronic Dartboard is straightforward. First, choose a location with at least 10 feet of clear space in front of the board. Next, measure 68 inches (172.7 cm) from the floor and mark the wall where the bullseye will be. Use a stud finder to locate wall studs for the most secure mounting. If you can't mount to a stud, use the provided hardware. Measure 7 inches (17.7 cm) directly above the bullseye mark and create a second mark. Use a level to ensure the marks are aligned vertically. From the top mark, measure 2 3/4 inches (6.9 cm) to both the left and right and mark these points. Drill pilot holes at the outer marks, and insert wall anchors if necessary, following anchor instructions. Insert screws, leaving about a 1/4-inch (6.5 mm) gap under the screw heads. Finally, position the dartboard so that the screw heads fit into the keyholes on the back. Slide the dartboard down about 1/2 inch to secure it. Tighten the screws. Always refer to the Fat Cat 727 Electronic Dartboard instruction manual for specific details and safety guidelines.