How can I install the Xicato XCC-C-SR14-SA Shallow Rectangle 14 Square Channel?

[Diaz]

Installing the Xicato XCC-C-SR14-SA Shallow Rectangle 14 Square Channel involves a few straightforward steps. Here's a guide to help you through the process:

Tools You'll Need: You will need a drill and a screwdriver.

Installation Steps:

Method 1: Direct Mounting

1. Drill holes (minimum 10mm diameter) in your desired mounting surface to accommodate the extrusion.
2. Insert the spring into the isolating base.
3. Mount the LED strip inside the extrusion, carefully leading the cable out.
4. Insert the cover to enclose the LED strip.
5. You can route the power cable through a hole drilled in the extrusion or through a hole in the end cap.
6. Slide the spring into the extrusion, and then insert the end caps to secure the channel.
7. Connect the power supply to the LED strip and insert the extrusion into the prepared holes.

Method 2: Mounting with Brackets

1. Feed the power cable through the appropriate channel.
2. Attach the mounting brackets to your mounting surface using screws.
3. Mount the LED strip into the extrusion, ensuring the power cable is routed correctly.
4. Insert the cover and end caps.
5. The cable can be routed either through a hole in the extrusion or through the end cap, depending on your setup.
6. Connect the power to the LED strip.
7. Mount the extrusion onto the mounting brackets.

Important Considerations:

• Make sure all LED strips are connected to a 24V power supply.
• These instructions offer a general overview. For detailed instructions, and additional mounting methods, please refer to the official Xicato XCC-C-SR14-SA Shallow Rectangle 14 Square Channel installation guide or visit www.Xicato.com for more specific guidance and accessories.