How can I install the Leviton 41089-6EP QuickPort Surface Mount Housing?

[WalkerRose]

Installing the Leviton 41089-6EP QuickPort Surface Mount Housing involves a few straightforward steps. First, identify the port side and the cable entry side of the base. Next, attach the base to your wall using either the provided 1-inch screws, double-sided tape, or self-adhesive hook and loop strips; ensure a secure mount. After that, terminate the wire onto the QuickPort snap-in adapter or connector, following the instructions specific to that connector type. Now, insert the connector into the housing at an angle, rotate it, and then push it firmly into the base. Finally, secure the jack by swinging the back portion down and forward until it clicks and locks behind the retention ledge on the base. To remove the jack later, use a small flat screwdriver in the retention ledge slot on the base and gently pry upward. For detailed diagrams and further information, consult the Leviton 41089-6EP QuickPort Surface Mount Housing User Manual. Remember to prioritize safety and seek professional assistance if you're uncertain about any step.