Installing your new KUCHT Professional K6502D Built-In Dishwasher involves a few key steps. It's recommended to consult the full instruction manual for detailed diagrams and specific instructions. Here’s a general guide:
-
Prepare the Enclosure: Ensure the cabinet opening is at least 24 inches deep and wide, with a maximum height of 35 inches. The dishwasher must be fully enclosed on the top, sides, and back, and must not support any part of the enclosure. Maintain at least a 2-inch clearance from adjacent cabinets, walls, or other appliances. Adhere to local codes regarding drain requirements, using an air gap or high drain loop to prevent backflow.
-
Electrical Wiring: Turn off the power supply at the source. Use a two-wire with ground electrical cable that complies with local codes. Connect the dishwasher's wires (white, black, and green) to the corresponding house wiring using UL Listed wire nuts. Secure the house wiring to the junction box with a strain relief.
-
Hot Water Line Connection: Shut off the water supply. Install a hand shut-off valve in an accessible location, such as under the sink. Connect the hot water inlet line to the dishwasher's water connection using a 90° elbow, ferrule, and compression nut. Set the water tank (heater) temperature between 120°F and 150°F. Flush the water line to remove any debris.
-
Drain Hose Installation: Attach the hose clamps to the drain hose. Connect the drain hose to the drain hose installation hose and tighten the clamps. Insert the drain hose through the cabinet wall hole.
-
Partially Slide in the Dishwasher: Carefully slide the dishwasher into the cabinet, ensuring the drain hose isn't kinked and the water line and wiring are unobstructed. Stop when the dishwasher is a few inches from the adjacent cabinetry.
-
Position and Level the Dishwasher: Check that wires are secure and don't contact door springs or other components. Push the dishwasher into the cabinet until the door corners are flush with the cabinet doors. Use a level to ensure the dishwasher is level and adjust the leveling legs as needed.
-
Secure to Countertop: Use the provided installation brackets and screws to secure the dishwasher to the countertop. Follow the instructions for either Method 1 or Method 2, depending on your countertop material.
-
Connect Water Supply: Connect the water supply line to the 90° elbow using a compression nut and ferrule. Ensure the door spring doesn't rub or contact the fill hose or water supply line.
-
Connect Drain Line: Follow local codes for drain line installation. Connect the drain line to the air gap, waste tee, or disposer, using the appropriate method.
-
Connect Power Supply: Turn the power supply back on. Remove the junction box cover and connect the dishwasher's wires to the house wiring using wire nuts. Replace the junction box cover.
-
Pre-Test Checklist: Review the checklist in the manual to confirm all installation steps are complete. Check for leaks and proper door balance. Run a wet test to verify operation.
-
Install Toe Kick: Place the toe kick against the dishwasher legs and align the slots with the toe kick bracket holes. Install the toe kick screws. Always refer to your KUCHT Professional K6502D Built-In Dishwasher's specific manual for precise instructions and illustrations.
