To connect your COMET Pt1000 Programmable Temperature Transducer to your PC for configuration, follow these steps:
- Begin by unscrewing the four screws on the device lid and carefully removing it.
- If the transducer is already integrated into a system, disconnect the leads from their terminals.
- Connect the SP003 communication cable to your device. When properly connected, the display should illuminate, or all symbols should briefly appear if the LCD was previously off.
- Next, connect the opposite end of the SP003 cable to an available USB port on your PC. The required USB driver should automatically recognize the connection and establish a virtual COM port on your computer.
- Launch the Tsensor software, which you should have installed on your computer. Within the Tsensor program, select the COM port that corresponds to the one created by the cable connection in the previous step.
- Within the Tsensor program, customize your transducer settings to your preferences.
- After you've saved your settings, disconnect the communication cable from the device.
- Finally, reconnect the leads to the device terminals and securely reattach the lid.
Ensure that the Tsensor program is installed and that the USB driver for the communication cable is correctly installed before attempting to connect. For detailed assistance, consult the "Calibration manual.pdf" included with the Tsensor software or reach out to your distributor for technical support.
