To configure your Alula RE103P Panic Button to trigger distinct alerts or commands based on different button press patterns, follow these steps:
-
Enter Programming Mode: Consult your specific alarm panel's instruction manual to learn how to enter its programming mode and navigate to the "Learn Sensors" or equivalent menu.
-
Activate Enrollment Mode on the Panic Button:
- Press and hold the Alula RE103P panic button for approximately twenty (20) seconds. The LED indicator on the panic button will blink three times, pause, and then remain illuminated for about three seconds.
- Continue holding the button until the LED blinks five (5) times. This indicates that the panic button is now in learn mode.
-
Enroll the Desired Zone: In learn mode, use the following button press patterns to enroll each zone:
- Zone 1 (Single Tap): Press and release the button once.
- Zone 2 (Double Tap): Press and release the button twice in rapid succession (less than 1 second apart).
- Zone 3 (Press and Hold): Press and hold the button for approximately 5 seconds, then release.
-
Panel Recognition: Repeat the button press pattern until your alarm panel successfully recognizes the serial number of the desired zone.
-
Zone Type Configuration: After the panel recognizes a zone, it is crucial to assign it a "chime only" zone type. This will allow you to receive notifications without immediately triggering a full alarm state.
-
Learn Mode Timeout: The Alula RE103P panic button's learn mode will automatically end after approximately 15 seconds of inactivity. If needed, simply re-initiate the learn mode to program additional zones.
By carefully following these steps, you should be able to configure your Alula RE103P Panic Button to send distinct alerts or commands depending on the button press pattern. For more specific instructions, detailed troubleshooting advice, or assistance, refer to the product manual or contact Alula customer support.
