Will you fail if you cross the line in Subject 3?

1 Answers
DePiper
07/29/25 5:40pm
Subject 3 will fail if you cross the line. The test content for driving license Subject 3 includes: Content 1: preparation for getting on the car, walking around the car counterclockwise for a week, fastening the seat belt after getting on the car, turning on the left turn signal, shifting into gear, releasing the brake, and honking the horn; Content 2: starting, driving in a straight line, shifting gears, changing lanes, parking by the roadside, going straight through intersections, turning left at intersections, turning right at intersections, passing through pedestrian crossings, passing through school zones, passing through bus stops, meeting oncoming vehicles, overtaking, making U-turns, and driving at night; Content 3: the test distance for small cars should be no less than 3 kilometers, and no less than 20% of the candidates should take the night test. If the night test is not conducted, the use of night lights should be simulated.
Was this review help?
8
1
Share
More Forum Discussions

Can Parking Lots Recognize Temporary License Plates?

Parking lots cannot recognize temporary license plates. Parking facilities only identify metal permanent license plates. If you need to enter a parking lot with a temporary plate, you should contact the staff. A temporary license plate refers to a paper motor vehicle license issued by traffic authorities that permits temporary road use before official vehicle registration. It's also called a temporary movement permit. These plates are typically valid for no more than 30 days. There are four types of temporary plates: intra-administrative district temporary plates, inter-administrative district temporary plates, test vehicle temporary plates, and special vehicle temporary plates.
13
2
Share

Is it allowed to reverse at a traffic light intersection?

Reversing at a traffic light intersection is not allowed and constitutes a traffic violation. According to the regulations in the Road Traffic Safety Law Implementation Ordinance: When reversing a motor vehicle, the driver should observe the situation behind the vehicle and confirm safety before reversing. Reversing is prohibited at railway crossings, intersections, one-way roads, bridges, sharp curves, steep slopes, or tunnels. When there is a conflict between traffic signals and police gestures, motor vehicle drivers must obey the on-site command of the traffic police. If a driver runs a red light due to police on-site command, they can obtain a traffic flow adjustment certificate from the local traffic police brigade to avoid penalties. If the party disagrees with the penalty, they can appeal through administrative reconsideration or administrative litigation.
15
2
Share

What is the difference between Land Cruiser and Land Cruiser Prado?

There is no difference between Land Cruiser and Land Cruiser Prado. Land Cruiser is actually Land Cruiser Prado. The different names are due to different naming conventions in different eras. In terms of body dimensions, the Land Cruiser Prado measures 4670 mm in length, 1905 mm in width, and 1830 mm in height, with a wheelbase of 2690 mm. Exterior-wise, the Land Cruiser Prado incorporates more sporty elements, highlighting the youthful appeal of the vehicle. The headlights are connected to the front grille, emphasizing the rugged and bold image of the car. In terms of configuration, the interior of the Land Cruiser Prado focuses on comfort, featuring user-friendly equipment and ample space. The high-quality audio system creates a premium in-car environment for both drivers and passengers.
16
2
Share

Should the clutch be released abruptly for a manual transmission launch control start?

No. The purpose of a launch control start in a car is to increase the engine speed to the maximum value that the transmission can withstand, thereby maximizing the torque at the wheels when the vehicle transitions from a stationary state to a moving state. Here are the details: Engage first gear: The clutch should be at the half-clutch point, and when the right foot presses the accelerator, maintain the engine speed around 2500-3000 RPM (too low RPM won't provide enough speed, while too high RPM will cause severe front-wheel spin, and prolonged spinning will affect the timing). Quick clutch release during start: With the right foot flooring the accelerator, closely monitor the tachometer during rapid acceleration. Shifting between gears must occur when the RPM reaches the redline zone at 6500 RPM. For naturally aspirated models, torque is proportional to RPM, so each gear must reach the redline zone to unleash maximum torque and achieve the strongest acceleration capability.
14
4
Share

What causes the humming sound when turning the steering wheel?

Reasons for the humming sound when turning the steering wheel are introduced as follows: Friction between plastic components: In this case, you can go to a 4S shop to replace the power steering fluid. Friction between the steering column and floor mat: The solution is to adjust the belt tension or replace the belt. Faulty airbag clock spring inside the steering wheel: Aging of the steering tie rod end with play, leaking of the steering gear dust cover, in this case, you may consider replacing the steering wheel. Steering gear failure: The solution is to replace the steering gear, replace the dust cover, or reapply grease. Faulty plane bearing or top rubber: The solution is to replace the steering tie rod end and perform a wheel alignment.
8
1
Share

Is it correct to yield to straight-going traffic when turning and yield to right-turning traffic when turning left?

Yielding to straight-going traffic when turning and yielding to left-turning traffic when turning right. The relevant details are as follows: Yielding to straight-going traffic when turning left: Yielding to left-turning traffic when turning right refers to the rule that left-turning vehicles must yield to straight-going vehicles, and right-turning vehicles in the same direction must yield to left-turning vehicles. When a vehicle passes through an intersection regulated by traffic signals, it should enter the guiding lane according to the intended direction of travel. Other situations: Vehicles preparing to enter a roundabout must yield to vehicles already inside the roundabout; when turning left, the vehicle should turn close to the left side of the intersection center point. Turn on the turn signal when turning, and use low beams when driving at night. When encountering a green light, pass through in sequence; when encountering a red light, stop in sequence outside the stop line. If there is no stop line, stop outside the intersection.
14
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.