Will Traffic Police Check Cars with Black Roof Stickers?

1 Answers
DiFaith
07/30/25 3:13am
Generally, traffic police do not check cars with black roof films. However, there is no precise or uniform answer to this question, as it largely depends on the enforcement practices of local traffic police. Additionally, they might check during surprise inspections. First, as long as the color change does not exceed 30% of the vehicle's total surface area, there is no need to report it to the vehicle management office—it is legal, and the vehicle will pass the annual inspection without issues. If the modification exceeds 30%, according to legal regulations, it must be reported to the vehicle management office; otherwise, it is considered illegal, and the vehicle will fail the annual inspection. For specifics, you can refer to the "Motor Vehicle Registration Regulations." The drawbacks of black roof films include the following: 1. They degrade over time: After prolonged use, the film can become unsightly due to aging and will need to be removed. However, removing it can be difficult, and even if you manage to peel it off, residual adhesive will likely remain on the roof, requiring additional cleanup. 2. Black absorbs heat: This is the most significant drawback. Most people are aware of this issue. Especially during summer, even brief exposure to sunlight can make the roof feel like a boiler, leading to increased air conditioning use and, consequently, higher fuel consumption.
Was this review help?
10
0
Share
More Forum Discussions

How to Prevent the Car Body from Crossing the Line When Reversing into the Garage?

Turning the steering wheel too early. When straightening the wheels, you need to do it a bit earlier than usual. Not turning the steering wheel to the full lock position in time. You should turn the wheels back after passing the usual point for returning to the straight position. The success rate this time is 99%. When reversing, turn the steering wheel to the right full lock position earlier, then straighten the wheels.
20
0
Share

How to Replace the Windshield Seal?

Prepare a small flat-head screwdriver and 401 special adhesive. First, handle the unglued seal to ensure the unglued area is smooth and free of wrinkles, otherwise the sealing effect cannot be guaranteed. Apply the 401 special adhesive to the tip of the small flat-head screwdriver. Do not apply the adhesive directly onto the seal to prevent leakage and contamination of the car body. After applying the adhesive, press the seal with one hand and slowly spread the adhesive from the screwdriver onto the unglued area with the other hand, moving from top to bottom. Gradually press the seal from top to bottom until all unglued parts are reattached. Finally, press back and forth a few times to ensure the seal is firmly adhered.
16
4
Share

How to Adjust the Time on a 2021 Audi Q3?

Turn on the ignition switch. Press and hold the protruding button in the middle of the instrument panel for 3 seconds. Once the hour digits start flashing, you can press the button up or down to adjust. After setting the hour, wait for 2 seconds until the minute digits start flashing, then continue pressing the button up or down to adjust. Once both the hour and minute are set, the time on the instrument panel will flash simultaneously. At this point, simply wait for 5 seconds to complete the process.
14
4
Share

How to eliminate the 'Keep Engine Running While Parked' warning?

Prompt indicates insufficient battery power or failure to detect battery charge. First, check if the battery terminals are loose and try tightening them. If the vehicle can still start, you may drive for half an hour. Alternatively, idling for one hour is also acceptable if you prefer not to drive, then observe whether the warning disappears. This indicates the battery previously had insufficient charge storage capacity, which could be due to battery degradation requiring replacement.
17
5
Share

How to Disassemble a Car Remote Key?

First, remove the mechanical key; after removing the mechanical key, you will see two holes, one for the mechanical key and another for removing the key cover plate. Insert the mechanical key into the hole for removing the key cover plate, and gently pry it open using the lever principle to access the battery cover of the key. Use a toothpick to remove the old battery and insert a new one; follow the reverse steps of disassembly to place the battery back into the car remote key.
2
5
Share

How to Locate Your Car When Someone Else Drives It Away?

Log in to the GPS manufacturer's mobile app and enter the corresponding identity information to check your car's location online. If your car is driven away by someone without your permission, you can report the case to the police and request traffic police to track it through the surveillance network.
13
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.