Will There Be Major Issues After a Rear-Ended Car Is Repaired?

1 Answers
StEdward
07/30/25 1:39am
Generally, there should be no structural issues, but the aesthetics will depend on how meticulous the repair work is. When getting it repaired, try to be polite to the bodywork technician or offer them a pack of cigarettes to ensure they pay extra attention. If your car was rear-ended and the other party is fully at fault, you can claim compensation from the insurance company by providing the driver's license and a copy of the compulsory traffic insurance. Below are the liability divisions for rear-end collisions on highways: 1. If the rear car hits the front car while it is moving: the rear car bears full responsibility. 2. If the front car lacks taillights at night: the front car bears secondary responsibility, while the rear car bears primary responsibility. 3. If the front car is parked on the road with hazard warning lights on and warning signs set up as required: the rear car bears full responsibility. 4. If the front car reverses or rolls back and hits the rear car: the front car bears full responsibility.
Was this review help?
2
5
Share
More Forum Discussions

How to Replace the Turn Signal Light on a Tiggo 3?

The method for replacing the turn signal light on a Tiggo 3: 1. For replacing the front turn signal light, first open the engine hood and locate the three soft covers behind the headlight assembly; 2. The left and right covers are for the low beam and high beam lights, and there is another cover below. Remove the cover to find the turn signal socket with a handle. Unscrew and pull it out, then rotate the bulb to remove and replace it. The Tiggo 3 is a model under Chery, offering six variants with a 1.6L engine, positioned as the 'Practical and Stylish SUV Benchmark'. In terms of body dimensions, the Tiggo 3 measures 4420mm in length, 1760mm in width, and 1670mm in height, with a wheelbase of 2510mm.
17
0
Share

How to adjust the crankshaft belt of Ford Mondeo?

The crankshaft belt of the Ford Mondeo is adjusted via the tensioner. The lower part of the cylinder block where the crankshaft is installed is called the crankcase, which is divided into the upper crankcase and the lower crankcase. The upper crankcase is cast integrally with the cylinder block, while the lower crankcase is used to store lubricating oil and seal the upper crankcase, hence also known as the oil pan. The Ford Mondeo is a model under Changan Ford, with body dimensions of 4873mm in length, 1852mm in width, and 1470mm in height, and a wheelbase of 2850mm. In terms of appearance, the Ford Mondeo has been redesigned in the grille, front fog lights, and wheel rims. The grille has been changed to a mesh pattern, and chrome trim has been added to the tail lights to enhance texture and sportiness, while the rest of the parts remain largely unchanged.
3
0
Share

What are the precautions for driving in hot weather?

Precautions for driving in hot weather are: 1. Prevent car spontaneous combustion: High temperatures in summer can cause items placed in the car to ignite if the car is exposed to prolonged sunlight; 2. Fatigue driving: High summer temperatures can easily lead to drowsiness, especially after long-distance driving. If you feel sleepy while driving, stop and rest immediately—never push yourself; 3. Prevent tire blowouts: As temperatures rise, prolonged exposure to sunlight can cause tires to burst. Summer heat affects tires through thermal expansion and contraction, increasing internal pressure and making blowouts more likely. Therefore, take breaks after long drives to let the tires cool down; 4. Monitor car water temperature: High summer temperatures can cause the engine to overheat, and frequent use of air conditioning adds to the engine's burden. Always check the engine cooling system when driving in summer. If the water temperature exceeds 100 degrees, stop and let the engine cool down.
16
2
Share

What are the steps for tire removal?

Tire removal steps are: 1. Check tire issues: Before replacing a tire, identify which tire has a problem; 2. Remove the wheel: First, loosen the wheel fixing bolts with a wrench. There are usually five or six fixing bolts. After loosening, do not remove them immediately. Lift the vehicle to an appropriate height, then remove the bolts and take the wheel off the hub; 3. Prepare for tire removal: Deflate the removed wheel, remove the balance weights on the rim, and then use a tire changer to separate the tire from the rim; 4. Remove the tire with a tire changer: Use the tire changer to separate the tire from the inner edge of the rim. Place the prepared wheel on the tire changer, secure the tire with the changer's clamps, insert a pry bar into the tire gap, and control the wheel's rotation via the foot pedal to separate the tire from the rim. Then remove the tire from the changer; 5. Install the new tire: After removing the old tire, place the new tire onto the rim in the correct direction. Use the same method to secure the partially installed tire on the tire changer, and manually assist the changer's rotation to fit the tire onto the rim; 6. Install the wheel: Mount the wheel with the new tire onto the hub, tighten the bolts, adjust each tire's pressure, reset the tire pressure, and finally conduct a test drive.
17
2
Share

Where is the Bluetooth located in the older Corolla models?

The older Corolla models do not have a physical button for Bluetooth. To turn on Bluetooth, you need to access it through the central control screen. Below is some related information about the Corolla: Bluetooth Connection Method: If you want to connect to the Corolla's Bluetooth, you need to enable Bluetooth on both the car and your phone, and set both to be discoverable by other devices. Then, simply pair and connect them. Powertrain: In terms of powertrain, the facelifted two-door Corolla models still primarily feature a 2.4-liter or 1.8-liter four-cylinder engine, paired with either a 5-speed manual transmission or a 5-speed automatic transmission. The higher-end 2.4-liter variant also offers an all-wheel-drive version.
4
3
Share

How Long After Getting a Driver's License Can You Drive?

After obtaining your driver's license, you are permitted to drive on the road. Below is an introduction to driving during the probationary period: Highway considerations: When driving a motor vehicle on the highway during the probationary period, you must be accompanied by a driver who has held a corresponding or higher-level driver's license for more than three years. During the probationary period, drivers are required to display a probationary sign on the rear of the vehicle. Additionally, drivers of small automatic passenger vehicles for the disabled may be accompanied by a driver who holds a license for small automatic passenger vehicles or above. During the probationary period for newly added permitted driving categories, driving a motor vehicle under the original permitted driving category is not subject to the above restrictions. Prohibited vehicles: During the probationary period, the driver's license holder is not allowed to drive buses, commercial passenger vehicles, police cars, fire trucks, ambulances, or other operational vehicles.
18
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.