Will There Be Issues If a Car Is Not Driven for Half a Year?

1 Answers
EliasLynn
07/30/25 3:10am
If a new car is left unused for six months, potential issues may include a battery that is not charged for an extended period, leading to power depletion and difficulty starting the car. Additionally, car tires subjected to prolonged pressure in one direction may experience uneven deformation. Therefore, it is advisable to start the car at least once a week and drive it for a few kilometers every two weeks or so. This ensures the battery gets charged, the tires bear even pressure, and the oil circuits in the engine remain active. Recommendations for long-term vehicle storage are as follows: 1. Before parking the car: Clean both the exterior and interior thoroughly. Applying wax or a coating can help protect the paint from corrosion. If possible, store the car in a garage. If parking outdoors, at least cover the car with a car cover to shield it from sun, rain, and debris like fallen leaves that could damage the paint. 2. For vehicles parked for extended periods: Avoid pulling the handbrake too tightly. The brake system, when left idle for long periods, can undergo chemical reactions with moisture and oxygen in the air, along with erosion from rainwater, leading to rust on the brake discs and pads. This rust can cause them to stick together, impairing brake performance. Upon restarting, this may result in wheel lock-up.
Was this review help?
1
4
Share
More Forum Discussions

What are the dimensions for parallel parking garages?

According to the relevant regulations in the "Specifications for Setting up Motor Vehicle Driver Examination Sites and Their Facilities (GA1029-2012)", the standard dimensions for parallel parking spaces are as follows: For large vehicles, the parking space width is 4 meters, with a length ranging from 7 to 10 meters depending on the vehicle type. For small vehicles, the parking space width ranges from 2.2 to 2.5 meters, with a length of 5 meters. Below are some parking precautions: 1. No parking in areas with no-parking signs: No-parking signs indicate that within the specified range, all vehicles are prohibited from parking temporarily or for an extended period. 2. No parking within yellow grid lines: Yellow grid lines indicate that parking is prohibited in this area for any reason. These are commonly found at intersections, entrances, and exits. 3. Yellow solid lines: Parking is prohibited on roadways with yellow solid lines. The length of the yellow solid line indicates the extent of the no-parking zone. 4. No parking near bus stops: Parking is prohibited in areas such as bus stops, gas stations, emergency stations, fire hydrants, etc.
20
0
Share

What are the requirements for tires in the 2020 annual vehicle inspection?

There are four main requirements for tires in the 2020 vehicle inspection, detailed as follows: 1. Installation: Tires of the same model, specification, and tread pattern should be installed on both sides of the same axle. Tire bolts and axle bolts should be complete and securely fastened. The tire specifications should match the motor vehicle product announcement and the motor vehicle factory certificate (for in-use vehicle inspections, it should match the motor vehicle registration information). 2. Damage: The tire tread and sidewall should not have cracks or cuts exceeding 25mm in length or deep enough to expose the tire cord layer, nor any other defects, abnormal wear, or deformations that affect usage. 3. Passenger cars, motorcycles, and trailers: The tread depth of the tire crown should be no less than 1.6mm. For other motor vehicles, the tread depth of the steering wheel tire crown should be no less than 3.2mm; the tread depth of the remaining tires should be no less than 1.6mm. 4. Highway buses, tourist buses, and school buses: All wheels and the steering wheels of other motor vehicles should not be fitted with retreaded tires.
3
3
Share

Should You Turn on AC and Recirculation When Using Car Air Conditioning for Cooling?

When using car air conditioning for cooling, it is essential to turn on the A/C switch. Here are some related additional details: 1. The reason for turning on AC and recirculation when using car air conditioning for cooling: If you turn on the cooling without activating AC and recirculation, only the blower in the car air conditioning system will be working, and the air coming out of the vents will be at normal temperature. The A/C switch in the car is the air conditioning control switch, which essentially controls the compressor. By turning the A/C switch on or off, you can control the operation of the car's air conditioning cooling system. 2. Turning on the A/C switch in winter: In extremely cold northern regions where outdoor temperatures can be near or below freezing, even if you turn on the A/C switch, the car's air conditioning cooling system may not operate. However, one benefit of turning on the A/C switch in winter is that it helps dehumidify the air, preventing the car's windshield from fogging up and obstructing the driver's view. Additionally, practical tests have shown that turning on the A/C switch while using the heater does not affect the interior temperature of the car.
18
0
Share

What is the fuel tank capacity of the Lexus ES200 in liters?

The fuel tank capacity of the Lexus ES200 is 60 liters, as officially announced. Owners who have purchased the Lexus ES200 can also check this information on the vehicle's configuration sheet. The Lexus ES200 requires 92-octane fuel, with a fuel consumption of 7.75L per 100 kilometers. A full tank of fuel allows for a driving range of approximately 774km. During daily driving, it is essential to monitor the remaining fuel level in the tank. This is typically observed through the fuel gauge inside the vehicle. Under normal circumstances, the fuel level will be accurately reflected on the gauge. The fuel gauge usually has 5 to 6 segments, and it is advisable to refuel when only 2 segments remain to avoid running out of fuel mid-journey. During actual refueling, the amount of fuel added may exceed the calibrated capacity. This is because the fuel tank capacity specified by the manufacturer measures from the bottom of the tank to the safe fill level, leaving some space between the safe fill level and the tank opening. This space ensures that the fuel can expand when temperatures rise without overflowing. If fuel is filled up to the tank opening during refueling, the actual amount of fuel added may exceed the calibrated tank capacity.
18
3
Share

Is it prohibited to drive a motor vehicle with a damaged driver's license?

It is prohibited to drive a motor vehicle with a damaged driver's license. According to Article 28 of the "Regulations for the Implementation of the Road Traffic Safety Law of the People's Republic of China": Motor vehicle drivers shall not drive motor vehicles when their driver's licenses are lost, damaged, expired, or during the period when they are legally detained or temporarily suspended, or when the accumulated demerit points reach 12. Below is additional information: 1. Required materials for replacement: A recent 1-inch bareheaded photo of the driver (white background); Original and photocopy of the driver's ID card; (Damaged old driver's license) For lost driver's licenses, write a loss statement in the blank space of the ID card photocopy, and add a signature and date; "Motor Vehicle Driver's License Application Form". 2. Before the expiration: Drivers who have lost their licenses and are applying for a replacement are within the period where they have not submitted a physical condition certificate (inspection). Please bring the original ID card of the driver to first complete the driver's license inspection according to the "Driver's License Inspection Work Process", and then proceed with the replacement process according to this work process.
7
0
Share

When Does the Timing Start for Parallel Parking?

From entering the parallel parking area to exiting the parallel parking area. Timing starts as soon as the vehicle enters the parallel parking test area, and ends when the vehicle exits the parallel parking test area. The time interval must not exceed 90 seconds. Below are the precautions for the Subject 2 driving test: 1. Fasten your seat belt: Buckle up as soon as you get in the car. Remember not to fasten the seat belt backward or on the passenger side, otherwise the system will directly judge the test as a failure. Do not unfasten the seat belt at will during the entire test. 2. Adjust the seat, etc.: After getting in the car, adjust the seat, adjust the rearview mirror, fasten the seat belt, turn on the left turn signal, shift into first gear, and release the handbrake. These six steps are indispensable. Make sure all preparations are complete before starting. 3. No stopping during the process: There is no time limit for reversing into the garage, but it is important to note that stopping during the reversing process is not allowed. If the wheels remain stationary for 3 seconds, the system will judge it as stopping midway. Therefore, controlling the speed is crucial. 4. The time for hill start is 30 seconds: The time for hill start is 30 seconds, and the system will give a voice prompt every 10 seconds. Exceeding 30 seconds will directly result in a failure.
12
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.