Will the Electronic Eye Capture Crossing a Single Yellow Line?

1 Answers
MatthewLynn
07/29/25 4:02pm
In areas equipped with electronic surveillance, the act of crossing a single yellow line will be captured as a traffic violation. Whether it's a single or double solid yellow line, neither should be crossed or driven over. Typically, traffic violations are recorded not only through automatic electronic surveillance but also manually by traffic police, so extra caution is advised. Below are the types of yellow road markings: 1. Double solid yellow lines: Similar to single solid yellow lines, double solid yellow lines are used to separate lanes of traffic moving in opposite directions and must not be crossed or driven over. Since double lines are used on roads with two or more lanes in each direction, electronic surveillance is more densely installed for double lines than for single lines. 2. Single dashed yellow lines: Single dashed yellow lines can be crossed or driven over, but drivers must be cautious of oncoming traffic. 3. Solid and dashed yellow lines: These are usually painted at turns or U-turn locations, allowing crossing only from the dashed side to the solid side. 4. Yellow no-stopping lines: The no-stopping line is also a single solid line, painted at the edge of the road, indicating that stopping is prohibited in this area.
Was this review help?
15
1
Share
More Forum Discussions

Will the Snorkel Let Water In on Rainy Days?

Generally, the snorkel does not let water in on rainy days, but it may allow water ingress if the wading depth is too deep. Here is some relevant information about snorkels: 1. Introduction: The more official term for a snorkel is "high-level intake pipe" or "wading device." Simply put, it is an extended intake pipe. 2. Function: The true purpose of a snorkel is to assist the engine by allowing it to breathe fresh air, thereby enhancing performance. Thus, wading is merely a secondary effect of the "snorkel." Installing a snorkel significantly raises the engine's air intake position, ensuring that the engine does not suck in water during off-road wading, which helps the engine operate more efficiently and intake air more fully.
14
2
Share

What Does Brake Linearity Mean?

Linear braking means that as the force applied to the brake pedal increases, the braking force also increases uniformly. Here is an introduction to the related content: 1. Linear braking vs. brake linearity: Brake linearity and linear braking refer to two different concepts. The former refers to the 'force' during braking, while the latter is a braking method. 2. Linear braking vs. non-linear braking: Progressive (also known as non-linear) braking simply means that the braking force increases with the pedal force, indicating that in emergency braking, pressing the pedal all the way down is effective. The quality of braking is always relative. Under the same brake disc and tire static friction conditions, linear braking will feel noticeably strong at the initial stage, but it's important to note that a strong initial force does not necessarily mean a shorter braking distance.
5
5
Share

Does Electric Vehicle Shock Absorber Oil Leak Affect Safety?

Electric vehicle shock absorber oil leakage does not affect safety in the short term. Here is some related information about shock absorbers: 1. Introduction: The shock absorber (Absorber) is used to suppress the oscillation after the spring absorbs vibration and rebounds, as well as the impact from the road. It is widely used in automobiles to accelerate the attenuation of vibrations in the frame and body, thereby improving the driving smoothness of the vehicle. When passing over uneven road surfaces, although the shock-absorbing spring can filter out road vibrations, the spring itself still undergoes reciprocating motion, and the shock absorber is used to suppress this spring bounce. 2. Working Principle: Most shock absorbers used in automotive suspension systems are hydraulic shock absorbers. Their working principle is that when relative motion occurs between the frame (or body) and the axle due to vibration, the piston inside the shock absorber moves up and down, causing the oil in the shock absorber chamber to repeatedly flow from one chamber to another through different orifices.
7
1
Share

What is the actual fuel consumption of the Ford Kuga 2.0T AWD?

The actual fuel consumption of the Ford Kuga 2.0T AWD is around 10L. The following factors affect vehicle fuel consumption: 1. Influencing factors: Engine displacement, vehicle weight, driving conditions, and air resistance can all impact fuel consumption. Even for the same vehicle, different driving habits can result in varying fuel consumption. 2. Increased fuel consumption: Frequent rapid acceleration or deceleration while driving can increase fuel consumption by approximately 5-30%. 3. Driving conditions: The road conditions can also affect fuel consumption. Driving on poor road conditions increases engine load, leading to higher fuel consumption.
10
0
Share

Reasons for Non-Responsive Window Switch After Water Ingress

Window malfunction reasons may primarily include circuit failure; deformation or damage to the window channel; loose screws on the window regulator; damaged window regulator; or misalignment of the guide rail installation. For restoration, it is recommended to visit a professional repair shop. Here are some maintenance measures for the window system: 1. Regular Window Cleaning: During daily use, windows are exposed to sun and rain, inevitably accumulating dirt. Excessive dirt can increase window lifting resistance, accelerating wear on the motor or rubber seals. 2. Inspect Window Rubber Components: If rubber components are not maintained periodically, aging or cracking of the rubber parts on the window may affect glass support and sealing integrity.
5
3
Share

What is the original spark plug model for GAC Trumpchi GS4?

Trumpchi GS4 uses NGK brand iridium spark plugs with the model number 454523. The benefits of replacing spark plugs include improved vehicle performance. Spark plugs are consumable parts that require regular replacement. If spark plugs are damaged, they can directly cause issues such as leakage in the vehicle's ignition system, increased fuel consumption, reduced power, and most notably, difficulty in starting the engine, affecting normal vehicle use. Severe spark plug erosion, such as scarring at the top, damage, or melted electrodes, indicates that the spark plug is damaged and should be replaced. Spark plug location: Spark plugs are installed on the side or top of the engine. In earlier models, spark plugs were connected to the distributor via ignition cables. Over the past decade, most car engines have switched to direct connection between the ignition coil and the spark plug. Spark plug replacement interval: Under normal maintenance conditions, spark plugs should be replaced every 40,000 to 60,000 kilometers. However, this may vary depending on the brand and engine type, so it's recommended to follow the user manual. Generally, platinum spark plugs should be replaced every 40,000 kilometers, ordinary nickel alloy spark plugs every 20,000 kilometers, and iridium spark plugs every 60,000 to 80,000 kilometers.
15
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.