···
Log in / Register

Will the car be scrapped if the engine is broken?

3 Answers
LaBarrett
08/26/25 5:44am
If the engine is damaged, the vehicle will not be scrapped; it can be replaced with a new one. Here is an introduction to engine maintenance: 1. Engine oil and oil filter: Regularly change the engine oil and oil filter. When the oil passes through the fine holes of the oil filter, solid particles and sticky substances in the oil are trapped in the filter. 2. Fuel system: Clean the fuel system regularly. During the process of fuel being supplied to the combustion chamber through the fuel lines, it inevitably forms gum and carbon deposits, which accumulate in the fuel lines, carburetor, fuel injectors, and combustion chamber, interfering with fuel flow, disrupting the normal air-fuel ratio, and causing poor fuel atomization. This can lead to engine issues such as shaking, knocking, unstable idle, and poor acceleration. 3. Radiator: Clean the radiator regularly. Rust and scale in the engine radiator are the most common problems. Rust and scale restrict the flow of coolant in the cooling system, reducing heat dissipation and causing the engine to overheat, which may even result in engine damage.
Was this review help?
14
1
Share
Laila
09/08/25 8:06am
Not necessarily. If the engine is broken, many cars can still be repaired, especially with the rapid advancement of technology. Personally, I think it depends on the value of the car and how much you're willing to spend. If the car is already very old or the repair cost is higher than its used market value, then scrapping it might be more cost-effective. But if it's a good car and replacing the engine only costs around ten or twenty thousand, why not repair it? After fixing it, you can still drive it for several more years. Don't forget to consider insurance and depreciation. When repairing, have a reliable mechanic check the overall condition—don't just fix the engine. Maybe even make some minor modifications to improve performance. In short, don't rush to scrap it; get quotes from several repair shops first.
Was this review help?
3
1
Share
Expand All
Diana
10/22/25 8:13am
I've been in this situation before. An engine malfunction doesn't necessarily mean it's totaled. Take my old car for example - three years ago it had severe oil leakage from the engine, and I thought it was done for. But my mechanic friend checked it and said just replacing a few parts would fix it. It cost me a few thousand yuan and was back to normal. The key is the type of damage - if it's just minor component issues like bad piston rings or spark plugs, repairs are easy. But if the entire engine is cracked or water-damaged from flooding, the repair costs would be so high that getting a new car makes more sense. Regular maintenance while driving can prevent this - avoid overloading and using poor-quality fuel, and change the oil regularly to extend its lifespan.
Was this review help?
3
1
Share
Expand All
More Forum Discussions

How Fast Can a 110cc Motorcycle Go?

It depends on the specific model. Currently, most 110cc motorcycles sold in the market are underbone models, and their top speeds vary. The fastest can reach 100–110 km/h, while more commonly, underbone motorcycles can only reach around 80–90 km/h. Below is an introduction related to engine displacement: Engine Displacement and Cars: The volume of space the piston moves from top dead center to bottom dead center is called the cylinder displacement. If the engine has multiple cylinders, the sum of the working volumes of all cylinders is called the engine displacement, usually expressed in liters (L). Engine displacement is one of the most important structural parameters, more representative of engine size than bore and cylinder count. Many engine metrics are closely related to displacement. Displacement Classification: In China, passenger car classification is determined by engine displacement. Micro cars have a displacement of ≤1.0L; compact cars range from 1.0–1.6L; midsize cars range from 1.6–2.5L; executive cars range from 2.5–4.0L; and luxury cars have a displacement >4.0L.
10
4
Share

Is it harmful for a 125cc scooter to run at 90km/h?

125cc motorcycles are not suitable for prolonged continuous high-speed operation at 90km/h, which is not beneficial for the engine. Precautions for riding a scooter: Choose mineral oil: It is not recommended to use fully synthetic lubricating oil, mainly because the oil change cycle during the break-in period is relatively short, and using fully synthetic lubricating oil would be somewhat wasteful. Ordinary high-quality mineral lubricating oil can meet the basic lubrication needs of a scooter engine. Change lubricating oil: During the break-in period of a scooter, apart from changing the lubricating oil, the main things to pay attention to are controlling the engine speed and maintaining a reasonable speed. Oil lubrication: The operation of the engine depends on the lubrication of the oil; otherwise, it will cause dry friction, and the internal parts of the engine will quickly wear out and fail prematurely.
15
0
Share

Is it okay not to downshift when emergency braking on a motorcycle?

When emergency braking on a motorcycle, it is actually acceptable not to downshift. This approach can utilize engine braking to shorten the braking distance and prevent loss of control. At worst, the engine may stall, but there are no other adverse consequences. Here are some key points to note about emergency braking on a motorcycle: Use both front and rear brakes simultaneously during emergency braking: Applying both brakes together is an effective method for achieving short-distance emergency stops. The primary braking force on a motorcycle comes from the front brake, which provides approximately 70% of the stopping power. However, 70% alone is insufficient; adding the braking force from the rear brake significantly enhances the overall braking effect. Pay attention to downshifting during braking: If there is sufficient braking distance and the rider can react in time, it is recommended to downshift after slowing down. If the rider is already in first gear during an emergency, they should maintain that gear. Additionally, it is best practice to downshift to first gear before coming to a complete stop each time.
20
1
Share

Where to Adjust for Motorcycle Lacking Power on Uphill?

Motorcycle lacking power on uphill can be adjusted at the clutch, because uphill power deficiency is usually due to insufficient power, and the common cause is clutch slippage preventing the engine's power from being normally output, resulting in uphill power deficiency. Function of the Clutch: The clutch is the component in the automotive transmission system directly connected to the engine. Its role is to smoothly engage or temporarily disconnect the engine's power from the transmission, reliably transmitting the engine's torque, facilitating the driver's operations such as starting, stopping, and shifting gears. Clutch Inspection Method: If the clutch pedal has no free play, it will cause clutch slippage, resulting in the vehicle lacking power during driving. If the clutch pedal's free play is too large, preventing the clutch from fully disengaging, it will cause difficulty in shifting gears. During inspection, depress the clutch pedal until resistance is felt. This distance is the clutch pedal's free play. The free play must be within the specified limit range of 6-13mm. If it does not meet the specifications, it should be repaired at a service station.
8
5
Share

What is the service life of a motorcycle?

Motorcycles have a service life of 10 years. Below is a detailed introduction to motorcycles: Motorcycle inspection requirements: The inspection can be extended for 3 years, but during this extension period, the motorcycle must undergo a semi-annual inspection. Only after passing the inspection can the extension be granted. After reaching 13 years of service, the motorcycle must be mandatorily scrapped. Motorcycle scrapping criteria: Light two-wheeled motorcycles, light three-wheeled motorcycles, two-wheeled motorcycles, and sidecar motorcycles with a cumulative mileage of 100,000 kilometers; three-wheeled motorcycles with a cumulative mileage of 80,000 kilometers; light two-wheeled motorcycles, light three-wheeled motorcycles, two-wheeled motorcycles, and sidecar motorcycles with a service life of 10 years; three-wheeled motorcycles with a service life of 9 years must be scrapped. Vehicle deregistration: If the motorcycle owner fails to complete the deregistration of the vehicle on time, the traffic management department of the public security authority will legally cancel the vehicle's registration certificate, license plate, and driving license, and will impound, penalize, and confiscate any motorcycles that continue to be driven on the road.
19
0
Share

What is the difference between a pushrod engine and a chain-driven engine in motorcycles?

Motorcycle pushrod engines and chain-driven engines differ only in the structure of their valve trains, and there is no inherent relationship with torque levels. Below are the relevant introductions: Chain-driven engine structure: Structurally speaking, chain-driven engines are more advanced. Chain-driven engines can increase power by raising the engine speed under the same displacement. They are compact, lightweight, have lower mechanical loads, precise ignition timing, and can integrate many advanced technologies. Therefore, high-performance, large-displacement sports bikes mostly use chain-driven engines, but they also demand higher manufacturing technology. Pushrod engine structure: Pushrod engines themselves are not suitable for high-speed operation, so they play to their strengths by typically designing the cylinder with a small bore and long stroke. This increases torque and avoids the drawbacks of high-speed operation. At medium to low speeds (commonly used range), they provide strong torque, powerful acceleration, excellent climbing performance, and good practicality.
2
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.