Will the 2021 Toyota 86 be introduced to the domestic market?

1 Answers
HarperMarie
07/29/25 4:33pm
Toyota 86's return to the domestic market in 2021 is almost impossible. Affected by the 2017 "Passenger Car Corporate Average Fuel Consumption Accounting Method," the Toyota 86 was forced to withdraw from the Chinese market due to its high emissions. In addition to emission restrictions, another reason is the low sales volume of the 86 in China. Below is an introduction to the Toyota 86: Exterior: The design of the current model is largely retained, with sharp front headlights paired with a large-sized grille, giving it a very aggressive look. The side profile features clean and stylish lines, creating a posture reminiscent of an eagle diving downward. The rear design is conventional but becomes quite sporty with the addition of robust dual exhaust pipes. Powertrain: The new car is expected to continue using a 2.0L naturally aspirated horizontally opposed engine, mated to either a 6-speed manual or 6AT transmission. It delivers a maximum horsepower of 200 PS and a peak torque of 205 Nm. Additionally, the car comes standard with a Torsen limited-slip differential on the rear axle, significantly enhancing its handling performance.
Was this review help?
4
1
Share
More Forum Discussions

What does it mean when the VSC is checked in a Reiz?

When the VSC system is checked in a Reiz, it means there is a fault in the electronic stability control system. Below are the features of the VSC system: Real-time Monitoring: The VSC system can monitor the driver's control actions (steering, braking, and throttle, etc.), road conditions, and the vehicle's motion state in real-time, continuously sending commands to the engine and braking system. Active Intervention: The VSC system can actively regulate the engine throttle to adjust the engine's speed and modify the driving and braking force of each wheel to correct oversteering and understeering. Prior Warning: When the driver operates improperly or encounters abnormal road conditions, the VSC system will alert the driver with a warning light.
13
2
Share

What is the maintenance interval for FAW-Volkswagen vehicles?

Most Volkswagen models require the first maintenance at 5,000 kilometers, with similar overall maintenance schedules. This is determined based on various factors such as road conditions, air quality, and fuel quality. After the initial maintenance, the oil and oil filter can be replaced every 5,000 kilometers. Vehicle maintenance is divided into external and internal maintenance: 1. External maintenance: This refers to the anti-aging care for the body surface, paint, and underbody coating, such as car coating, waxing, tire maintenance, tire pressure measurement, car cleaning, and window tinting, all of which help maintain the car's underbody coating and overall condition. 2. Internal maintenance: This includes interior cleaning, interior steam disinfection, engine cleaning, air conditioning cleaning, oil changes, windshield washer fluid replacement, and underbody armor, all of which are methods to maintain the vehicle.
2
2
Share

How to Turn on the Heater in a 2008 Toyota Crown?

08 Toyota Crown heater activation steps are: 1. Start the car and wait approximately 4-5 minutes until the coolant reaches normal operating temperature, then activate the heater; 2. Adjust the air conditioning system to recirculation mode; 3. Switch to warm air mode (red zone setting); 4. Do not engage the AC compressor as the heating system utilizes the vehicle's own thermal cycle for energy efficiency; 5. Set appropriate fan speed and adjust vent direction. The Toyota Crown was available in four trim levels across seven grades, all powered by a 3.0L dual VVT-i engine paired with a 6-speed automatic transmission, built on a front-engine rear-wheel-drive platform. Vehicle dimensions measure 5020mm (length) × 1805mm (width) × 1480mm (height) with a 2925mm wheelbase, featuring double wishbone front suspension and multi-link rear suspension.
2
0
Share

What Causes the Abnormal Noise Inside the Car When Accelerating?

It is abnormal for a car to make strange noises when accelerating. The reasons for abnormal noise when stepping on the accelerator are as follows: Fuel pump motor noise: When the fuel pump motor is internally worn or contaminated with impurities, it will produce abnormal noises as the driver presses the accelerator. In such cases, the fuel pump needs to be replaced. Throttle body noise: Modern throttle bodies are electronic. The motor controls the opening and closing of the throttle valve. When the motor gears are worn, inadequate meshing can cause abnormal noises. Excessive carbon deposits or sludge in the throttle body can also lead to noise. The throttle body can be cleaned, but if the motor is damaged, the throttle body must be disassembled to replace the servo motor. Poor lubrication of the accelerator pedal bearing: Poor bearing lubrication can cause abnormal noises. You can apply grease to the bearing for lubrication.
20
2
Share

What is the method for controlling the clutch?

Control method for the clutch: Use the ball of your foot to firmly press the clutch pedal with the heel as the pivot point, and release the pedal slowly. Automotive clutches can be categorized into: 1. Electromagnetic clutch; 2. Magnetic particle clutch; 3. Friction clutch; 4. Hydraulic clutch. The clutch is installed between the engine and the transmission, and its functions include: 1. Gradually increasing the driving force of the vehicle for a smooth start; 2. Temporarily separating the engine and transmission for gear shifting; 3. Preventing overload of the transmission system; 4. Reducing torsional vibration impacts from the engine to prolong the lifespan of transmission gears. Maintenance and servicing items for the clutch include: 1. Checking the fluid level in the clutch reservoir; 2. Inspecting the hydraulic control mechanism of the clutch for leaks; 3. Depressing the clutch pedal to check pedal responsiveness; 4. Checking the height of the clutch pedal.
11
3
Share

How to Apply Car Wax Correctly?

This is because the car has been waxed, usually resulting in water droplets not running down. The benefit of waxing is to protect the car's paint. Below is a relevant introduction about car waxing: 1. The functions of car waxing: As a traditional car care procedure, waxing serves to waterproof and protect against acid rain. Due to the protection of car wax, the amount of water droplets adhering to the car body is significantly reduced, with an effectiveness rate ranging from 50% to 90%. Another function is to protect against high temperatures and UV rays. As the weather gets hotter, cars that are driven or parked outdoors year-round can easily suffer from paint aging and fading due to sunlight exposure. The film formed by waxing can reflect some of the light. 2. Precautions for car waxing: Depending on the driving environment and parking location of the vehicle, the interval between waxing sessions should vary. Before waxing, it is necessary to thoroughly clean dirt and dust from the car's exterior.
1
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.