···
Log in / Register

Will it be a problem if a tire crushes a beer bottle?

3 Answers
DiTheo
08/31/25 6:22am
Generally, it's not a problem as the front side of the tire is very sturdy and not easily damaged. Here is some relevant information about tires: 1. Introduction to tires: Tires are the only parts of a car that come into contact with the ground. Some car owners only replace the tires on the drive wheels when changing tires. For example, some front-wheel-drive car owners only replace the two front tires, while some rear-wheel-drive car owners only replace the two rear tires. In fact, this practice is acceptable. 2. Tire aging: Tires are rubber products and will age over time. It is recommended that car owners replace their tires every four years, even if the mileage is low within those four years. Since tires can also age when left unused for long periods, it's important to check the production date when purchasing new tires.
Was this review help?
9
4
Share
GenevieveAnn
09/13/25 2:46am
Last time I ran over a beer bottle while driving, it scared me so much that I immediately pulled over. Glass shards are extremely sharp - if the tire rolls over them, fragments can get lodged in the tread grooves and cut through the rubber layer, potentially causing air leaks or blowouts. The tire sidewalls are particularly vulnerable; if pierced by glass, rapid deflation could occur, increasing danger at highway speeds. After running over debris, carefully inspect the tires by running fingers along the tread to check for embedded objects, using pliers to gently remove any found. Even if no damage is visible, drive slowly to the nearest repair shop. Develop good driving habits: always watch for road debris and avoid running over bottles or cans. Damaged tires require immediate replacement or professional repair - continuing to use compromised tires invites roadside emergencies. Safety must always come first - never take tire hazards lightly.
Was this review help?
16
2
Share
Expand All
OEvelyn
10/27/25 3:33am
From a material perspective, tire rubber is relatively soft, while beer bottle glass is hard and brittle. When crushed, glass fragments can easily embed into tires. Particularly in areas with deep tread patterns, glass shards may get lodged, gradually wearing down the rubber and causing punctures or sidewall bulges. Under pressure, fragments may pierce the tire wall, leading to blowouts. Wheel rims can also sustain minor scratches. After driving over glass, immediately inspect the tire surface and remove all glass residues. Passenger car tires are thin and prone to damage—it's advisable to drive slowly afterward while monitoring tire pressure changes. A good practice is to regularly clean tread patterns to prevent debris accumulation. Always pay close attention to safety driving details.
Was this review help?
16
2
Share
Expand All
More Forum Discussions

What level is the X-Trail?

The X-Trail is a compact SUV, positioned between the A+ and B segments. Below are the relevant details about the X-Trail: 1. Suspension: The front suspension is a MacPherson strut independent suspension, and the rear suspension is a multi-link independent suspension. 2. In terms of power, the X-Trail is equipped with naturally aspirated engines, available in 2.0-liter and 2.5-liter displacements. The 2.0-liter version delivers a maximum horsepower of 154 hp, while the 2.5-liter version offers a maximum horsepower of 186 hp. 3. Drivetrain: The 2.0-liter versions are all front-wheel drive, whereas the 2.5-liter versions are all four-wheel drive.
11
4
Share

What does the BMW 3 Series head-up display show?

BMW 3 Series head-up display shows speed, door opening/closing prompts, and music module information. The purpose of the head-up display function: Its function is to project important driving information such as speed and navigation onto the windshield in front of the driver, allowing the driver to view critical driving data without lowering or turning their head. Precautions for using the head-up display: The driver-centric design makes it more convenient to view the car screen and operate knobs while driving; blind operation allows the driver to keep their eyes on the road; when navigation information is displayed on the multifunctional dashboard, it minimizes distraction by reducing the need to shift attention.
20
4
Share

What Causes the Metal Friction Noise During Cold Engine Start?

If there is a metallic sound coming from the exterior when starting a cold engine, it may indicate damage to the bearings of the generator, water pump, or power steering pump. Below are relevant details: 1. Engine abnormal noise signifies a change in the technical condition of a certain engine mechanism. This is mainly caused by excessive wear of some components or improper assembly and adjustment. Some abnormal noises can even forewarn of potential catastrophic engine damage. Therefore, when abnormal noise is detected, timely repairs should be conducted to prevent further fault escalation. Before disassembly, preliminary inspections should be performed to roughly identify the faulty area. Then, by analyzing the characteristics of the engine noise, the location, cause, and severity of the noise can be diagnosed, avoiding blind disassembly. 2. The V-belt is the most common type of belt used for power transmission. It is readily available at an economical price and easy to replace. When the V-belt shows signs of wear or becomes loose, the engine compartment may emit a "squeaking" noise. If the wear on the V-belt is severe, replacement is necessary.
19
5
Share

What does the oil life display on the Envision mean?

When the Envision displays oil life, it indicates that the health status of the oil is insufficient and needs to be replaced promptly. Determining the condition of the oil: If the three rings are clearly distinguishable, the oil can continue to be used; if the oil ring disappears, leaving only the deposit ring and diffusion ring, it is recommended to replace the oil; if only the darker-colored deposit ring remains, the oil needs to be replaced immediately. The functions of engine oil: Engine oil lubricates and reduces friction, assists in cooling, seals against leaks, prevents rust and corrosion, and provides shock absorption. Engine oil consists of base oil and additives. The base oil is the main component of lubricating oil, determining its basic properties, while additives compensate for and improve any deficiencies in the base oil's performance and provide certain new properties.
10
3
Share

What's the difference between Volkswagen Tayron and Tharu?

Tayron is Tharu, Tayron was the rumored name for Tharu before its official naming, so it is now called Tharu. Introduction to Tharu's exterior: Tharu adopts Volkswagen's new family-style design language, featuring a horizontal grille at the front and LED headlights on both sides, effectively extending the horizontal visual width. The waistline extends from the headlights to the taillights, with a rounded and grand rear design. The overall vehicle's robust lines create a muscular feel. Introduction to Tharu's interior: Tharu features the latest family-style design, with the dashboard slightly tilted towards the driver's seat for easier operation. The lower part of the dashboard and the gear shift area follow a more traditional, simple layout. The 10.3-inch full LCD instrument panel paired with a 9.2-inch central touchscreen and 10-color adjustable ambient lighting make the interior more youthful and stylish.
15
5
Share

How to Step on the Clutch and Brake When Turning?

Here are some tips for stepping on the clutch when turning: 1. When turning, make judgments based on the situation. If it's a wide turn, you don't need to shift gears. Just control the speed and gently press the brake to slow down, then accelerate after the turn. 2. If you encounter a sharp turn with a small radius, slow down in advance and downshift. Not slowing down may cause the car to lose control, and not downshifting may lead to insufficient power, causing the car to shake or even stall. After downshifting, turn while keeping the gear engaged. Here are some precautions when turning a car: 1. When turning, adjust the steering wheel according to the curve of the road and coordinate it with the car's speed. 2. Ensure the steering angle is appropriate, the timing of turning is right, and the steering wheel is turned back promptly. Never take both hands off the steering wheel to avoid dangerous deviations.
18
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.