Will I be fined for driving 110 in a 100 speed limit zone on the highway?

Which finger is used for the fingerprint in Subject 2?

Subject 2 fingerprint recording generally requires the use of the thumb, index finger, or middle finger. According to examination regulations, candidate identity verification is required before both Subject 2 and Subject 3 tests, primarily through ID card verification and fingerprint scanning. Theoretically, if fingerprint recording is part of the pre-exam process in your region, it is a mandatory step before the test begins. Below is related information: 1. Definition of Subject 2: Subject 2, also known as the small road test, is part of the motor vehicle driver's license assessment and refers to the field driving skills test. 2. Content of Subject 2: The test includes five mandatory items: reversing into a garage, parallel parking, stopping and starting on a slope, right-angle turns, and curve driving.

14

5

Share

Is a mock test still necessary for the second attempt at Subject 2?

The necessity of a mock test entirely depends on the candidate's confidence level. If the candidate feels fully prepared, a mock test may not be required. Purpose of the mock test: It aims to familiarize candidates with the exam environment and allows instructors to point out areas prone to point deductions. Therefore, mock tests are absolutely essential—thorough preparation is key to optimal performance. Definition of Subject 2: Subject 2, also known as the small road test, is part of the motor vehicle driver's license assessment and refers to the field driving skills examination. Content of Subject 2: For car licenses C1 and C2, the test items include five mandatory components: reverse parking, parallel parking, stopping and starting on a slope, right-angle turns, and curve driving (commonly known as S-turns).

13

5

Share

How Long Does It Take to Practice Driving Before Going on the Road Alone?

The time it takes to practice driving before going on the road alone varies from person to person. Those with a good foundation may only need 2 to 4 hours, while those with a weaker foundation may require 10 to dozens of hours. For better safety assurance, it is generally recommended to practice for about 10 hours. This will help you adapt to most typical road conditions in urban areas. Below are some related points: 1. No highway driving during the probationary period: Generally, drivers can drive on highways only after completing a one-year probationary period after obtaining their license. If traffic violations occur during the probationary period, the period may be extended by another year, making it two years in total. 2. Highway driving during the probationary period: If you need to drive on highways during the probationary period, you must be accompanied by someone with at least three years of driving experience.

1

Share

What are the rules and requirements for the Subject 1 exam?

Subject 1 exam has a total duration of 45 minutes. The exam paper consists of 100 questions, including true/false and single-choice questions, with a full score of 100 points and a passing score of 90. The exam paper is randomly selected and combined by the computer driver's exam system according to the proportion specified in the "Motor Vehicle Driver's License Work Regulations". Below is the relevant introduction: 1. Introduction to Subject 1: This exam is a related basic theory test, mainly assessing the most fundamental road knowledge. 2. Content of Subject 1: The Subject 1 exam paper is a paperless computer-based test with a total of 100 questions, each worth 1 point, totaling 100 points. The question types are choice-based true/false and single-choice questions. Candidates must answer within 60 minutes and achieve a correct answer rate of 90 points to pass.

11

2

Share

What are the differences between the first and second sessions of Subject 3?

There is no difference between the first and second sessions of Subject 3. The only variation is that if a student fails the first session, they will be given a second session as a retake. If the student passes the first session directly, there will be no second session. If the student fails the second session as well, they will have to re-register for Subject 3, but the exam content remains the same. Below is an introduction to Subject 3: 1. Definition of Subject 3: Subject 3, which includes the road driving skills test and the safe and civilized driving knowledge test, is part of the motor vehicle driver's license assessment. It is the abbreviated term for the road driving skills and safe and civilized driving knowledge test in the motor vehicle driver's examination. 2. Content of Subject 3: Vehicle preparation, simulated nighttime lighting test, starting, driving in a straight line, gear shifting operations, changing lanes, pulling over, proceeding straight through intersections, turning left at intersections, turning right at intersections, crossing pedestrian crossings, passing school zones, passing bus stops, meeting vehicles, overtaking, making U-turns, and nighttime driving.

15

0

Share

How to Judge the Distance of the Rear Car When Changing Lanes?

To accurately judge the distance, first observe the distance of the rear car and adjust the rearview mirror properly. When the rear car fills the entire rearview mirror, the distance between the two cars is approximately 3 meters. When the rear car fills the left rearview mirror, the actual distance is about 1 meter. When the rear car fills the right rearview mirror, the distance between the two cars is very close, and these situations are not safe distances. Changing lanes under such conditions is dangerous. More details are as follows: 1. When the rear car fills half of the right rearview mirror: The distance between the two cars should be about 9 meters. For experienced drivers, this distance is relatively safe, but novice drivers may find it difficult to master and need to be extra cautious. When the rear car fills 1/3 of the left rearview mirror, the distance between the two cars should be about 10 meters, and from the right side, it should be about 12 meters. Generally, such distances can be considered safe, but at high speeds, if the car in front brakes suddenly or overtakes, it can still be dangerous. 2. Observing the distance of the car in front: If you can see the upper edge of the rear bumper of the car in front, the distance is about 1 meter, and you should be cautious about sudden braking by the car in front, as it may lead to a rear-end collision. If you can see the lower edge of the rear bumper, the distance is about 2 meters, which is ideal in traffic jams. If you can see the lower edge of the rear wheel hub of the car in front, the distance is about 3 meters, but in heavy traffic, this distance may allow other cars to cut in. 3. Maintaining a good field of vision while driving: This is one of the conditions for safe driving. Therefore, before driving, adjust your seat position and rearview mirrors properly. In crowded areas, maintain a safe distance from the car in front, but also avoid leaving too much space, which may invite other cars to cut in. Especially on roads with many electric vehicles, which are unpredictable, extra caution is needed. When changing lanes, leave enough space, ideally with the rear car occupying only 1/3 of your rearview mirror, for safer maneuvering. Develop correct driving habits and avoid speeding.

9

5

Share

Will I be fined for driving 110 in a 100 speed limit zone on the highway?

Which finger is used for the fingerprint in Subject 2?

Is a mock test still necessary for the second attempt at Subject 2?

How Long Does It Take to Practice Driving Before Going on the Road Alone?

What are the rules and requirements for the Subject 1 exam?

What are the differences between the first and second sessions of Subject 3?

How to Judge the Distance of the Rear Car When Changing Lanes?

What is the structure of a gasoline engine?

How Many Years of Driving License Are Required to Drive on Highways?

How long does it take to restore 12 points after deducting 9 points from a driver's license?

Will a tire be punctured if it runs over a glass bottle?