Will I Be Caught for Making a Right Turn from a Straight Lane?

1 Answers
VonTheo
07/30/25 10:36am
If you make a right turn from a straight lane, you will be caught, which will result in a fine and penalty points. Therefore, it is crucial to pay attention while driving. If you enter the wrong lane, follow the lane's designated direction and make a U-turn at the next intersection. Additional details are as follows: 1. Lanes: Generally, lanes that allow right turns are located on the far right, while lanes that allow left turns are on the far left. The middle lanes are designated for straight traffic. Different lanes are set up to maintain traffic order. If vehicles drive randomly without adhering to lane rules, it can easily lead to accidents and traffic congestion. Always drive in the correct lane. 2. Strictly adhere to traffic rules when driving on the road: Following traffic rules is not just about avoiding fines or penalty points but also about ensuring your safety and that of others, as well as maintaining good traffic order. When driving on the road, never exceed the speed limit or drive under the influence of alcohol. Always obey traffic signals while driving.
Was this review help?
1
1
Share
More Forum Discussions

What is ecowing tire?

ecowing is a Kumho tire. Here are some related introductions about tires: 1. Wear: Tires have wear indicators. There are triangle marks on the sidewall of the tire. When the tread wears down to the level indicated by the triangle mark, it is recommended to replace the tire. There are also raised markers inside the tread grooves. When the tread wears down to the level of these raised markers, the tire should be replaced. Simple punctures can be repaired without needing replacement, but bulges must be replaced. 2. Aging: Rubber oxidizes in the air, and oxidized rubber hardens, reducing grip. Therefore, even if a set of tires is not used, their lifespan will still decrease. It is not recommended to use tires for more than 5 years from the date of production. The production date can be found on the sidewall of the tire.
14
4
Share

What kind of lubricating oil should be added to a centrifugal pump?

Centrifugal pump bearings are lubricated with LHV-46 lubricating oil or L-HV-32 lubricating oil. Below is the relevant introduction: 1. Principle: Centrifugal pumps work by using the rotation of the impeller to generate centrifugal motion in the water. Before starting the pump, the pump casing and suction pipe must be filled with water. Then, the motor is started to drive the pump shaft, impeller, and water in high-speed rotational motion, causing the water to undergo centrifugal motion and be thrown to the outer edge of the impeller, flowing into the pump's pressure pipeline through the volute-shaped pump casing. 2. Main function: The main function of the bearing is to support the mechanical rotating body, reduce the friction coefficient during its movement, and ensure its rotational accuracy.
14
4
Share

What are the operating techniques for manual transmission?

Here are the specific operating techniques for manual transmission vehicles: 1. When starting the vehicle: After idling for about half a minute, press the clutch, shift into 1st gear, simultaneously press the foot brake with your right foot, release the handbrake with your right hand, and slowly lift the clutch. 2. While driving: When the speed reaches 15 to 20 km/h, shift into 2nd gear; when the speed reaches 25 to 30 km/h, shift into 3rd gear. 3. Decelerating and stopping: Press the brake to reduce the speed to a safe level, press the clutch, and shift into neutral. 4. Gear shifting: Depress the clutch fully in one motion, and shift gears decisively. Familiarize yourself with the gear positions. If you encounter difficulty shifting, shift into neutral, release the clutch briefly, then depress the clutch again to shift successfully.
2
5
Share

Does the Beijing Hyundai Elantra come in black?

The Beijing Hyundai Elantra is available in black. Here are some related details about the Beijing Hyundai Elantra: 1. The Elantra is equipped with two direct injection engines: a 1.6-liter and a 1.4T turbocharged engine, paired with a 6-speed manual transmission. It delivers a maximum output power of 95.3Kw and a peak torque of 157N·m, achieving a 0-100Km/h acceleration time of just 10.8 seconds and a top speed of 204Km/h. 2. The Elantra features LED daytime running lights, an electric sunroof, a D-Cut sport steering wheel, electrically adjustable exterior rearview mirrors, an 8-inch multimedia screen on the center console, a smartphone connectivity system, a vehicle stability system, rear parking radar/camera, and four front airbags, among other features.
13
2
Share

What Causes the Clutch to Stick and Prevent Gear Engagement?

Failure to engage gears is due to a malfunction in the vehicle. Below are the reasons why the clutch may prevent gear engagement: 1. Clutch cable failure: Some manual transmission vehicles still use cables to control the clutch. The outer sheath of the cable can easily crack, leading to difficulty in engaging gears. 2. Excessive gear lock force: An overly strong gear lock mechanism can make it difficult to shift in and out of gears. 3. Clutch master cylinder failure: The clutch hydraulic master cylinder may experience issues like pressure loss or oil leakage during use, resulting in failure to engage gears when pressing the clutch. In such cases, the clutch master cylinder needs to be replaced at a service station, followed by an air bleeding procedure. 4. Transmission failure: Insufficient transmission fluid, a stuck gear shift mechanism, or a malfunctioning gear or shift fork can also cause this issue.
13
5
Share

What are the three major categories of substances for tanker trucks?

Class III hazardous materials include flammable liquids such as diesel, gasoline, paint, acetone, kerosene, ethanol, and sulfur dioxide. Operating a hazardous material transport vehicle requires holding a 'Hazardous Materials Professional Qualification Certificate'. The following are the requirements for transport vehicles: 1. Box trucks for transporting gases: Box trucks transporting bottled compressed gases and liquefied gases must be equipped with ventilation devices and securing devices. 2. Special vehicles for transporting flammable and explosive materials: Special vehicles for transporting flammable and explosive materials must all be fitted with conductive rubber grounding straps that meet regulatory standards. 3. Vehicles for transporting horizontally placed bottled compressed gases: Special vehicles transporting horizontally placed bottled compressed gases and liquefied gases must have internal compartment widths that meet the length dimensions of the cylinders; otherwise, the vehicle must be replaced to meet transport requirements. 4. Vehicles for transporting oxides: Oxidizers and organic peroxides must be transported using temperature-controlled box-type special vehicles.
13
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.