Will a Broken Transmission Pan Damage the Transmission?

What Causes the Abnormal Noise When Raising and Lowering Mercedes-Benz Windows?

Introduction to the causes of abnormal noise when raising and lowering Mercedes-Benz windows: Accumulation of dust in the window rubber guide channel: Excessive dirt increases resistance, causing a creaking sound. The solution is to clean the glass guide channel. Prepare a cloth and a chopstick, wet the cloth with water, wrap it around one end of the chopstick, and secure it with a rubber band. Then insert this end into the glass guide channel and slide it back and forth to clean until no more dirt comes out, indicating it is clean. Aging of the rubber in the window glass guide channel: If there is slight hesitation and abnormal noise when raising or lowering the car window, use window lubricant to address the issue. It is easy to use—simply spray it onto the rubber. Loss of window initialization data: This can be resolved by reinitializing the windows. Turn on the ignition switch, hold the switch up to raise the window, and keep holding it for 5 seconds after the glass reaches the top. Then release the switch and immediately press and hold it again to lower the window. After the glass reaches the bottom, wait for more than 3 seconds, then hold the switch up again to raise the window, repeating the process once to complete the initialization.

12

4

Share

Why does the Pajero's side slip light come on and experience weak acceleration?

It is related to severe engine carbon buildup. Go to a 4S shop to clean the internal carbon deposits in the engine, clean the fuel injectors, clean the dirty intake manifold, and remove the carbon layer on the exhaust valve. The car's anti-slip system: The car's anti-slip system is another set of anti-slip control systems following ABS, and it is a further development and supplement to the ABS system. Main purpose of the anti-slip system: The main purpose of the anti-slip system is to prevent the drive wheels from slipping when the vehicle starts and accelerates, effectively maintaining the stability of the car's driving direction. Slip control is kept within a certain range to prevent the slipping wheels from rapidly sliding and causing the car to lose direction. Functions of the anti-slip system: The functions of the anti-slip system are to improve the car's traction and to maintain the car's driving stability. When the car turns, the drive wheels will not slip, preventing the car from veering to one side.

18

3

Share

Can a Rear Air Vent Be Installed in the New Cruze?

It is possible to install a rear air conditioning vent, but the installation process involves significant effort and may lead to unusual noises after some time of use. It is recommended to have it professionally installed at a 4S shop. Replacing the Dust Filter: Routine air conditioning system maintenance includes replacing the filter, using cleaning agents, and disassembling for cleaning. Replacing the dust filter is the simplest method, which is cost-effective and ensures smooth airflow. Car owners with basic mechanical knowledge can perform this cleaning themselves. In most compact cars, the dust filter is located under the front windshield, covered by the rain gutter. Disinfecting the External Air Circulation Duct: Remove the dust filter, start the vehicle, turn on the air conditioning, and set it to external circulation mode. Spray foam cleaning agent onto the dust filter. The external air circulation will draw the cleaning agent into the duct, disinfecting the duct, air conditioning evaporator, and heater core by breaking down bacteria and eliminating odors. The dirt will liquefy and drain out through the air conditioning outlet.

11

4

Share

Does replacing a BMW electric water pump require matching?

Replacing a BMW electric water pump does not require matching. Electric water pump bleeding method: First, fill the coolant to the maximum level and open the radiator cap. Then insert the key, turn on the ignition switch to power on, but do not start the engine. Next, set the air conditioning to heating mode and adjust it to the highest temperature, with the fan speed at the lowest setting. Press the accelerator pedal all the way down for about 10 seconds, and you will hear the sound of the electric water pump working. The pump will run for a while to expel the air from the engine. Precautions: Bleeding the electric water pump must be done when the engine is cold. When the coolant temperature is very high, it is strictly prohibited to open the radiator cap or drain valve to prevent burns.

19

5

Share

What are the length, width, and height of the Mercedes-Benz 450?

The Mercedes-Benz GLS450 has a body length of 5207mm, a width of 1956mm, and a height of 1834mm. Exterior design: The 2020 Mercedes-Benz GLS450 features more rounded headlight designs, moving away from sharp angles. The interior consists of two double-diamond-shaped light units, complemented by smooth LED daytime running lights on top, ensuring high visibility even during the day. The interior incorporates more wood grain trim panels and leather wrapping, maintaining Mercedes-Benz's elegant and noble temperament. Notable features: This new model also has a distinctive feature: a rear with an inclined or vertical tailgate. When the door is opened, the luggage compartment space connects with the passenger area. The new Mercedes-Benz GLS450 U.S. version showcases a body with robust yet dynamic lines, giving the entire vehicle a more dignified and imposing presence. The rear bumper is wrapped in matte-finish aluminum alloy, adding a textured wildness. In business settings, it exudes dominance, while for family members, the car provides a strong sense of security.

15

1

Share

What's wrong with the Audi A6 indicating steering failure?

It is due to a large amount of air in the power steering system, causing abnormal car steering; foreign objects in the steering hydraulic pipeline causing the steering pump flow control valve to stick; loose connections in the power steering system leading to steering fluid leakage. Abnormal noise when steering: The reason for abnormal noise when the car is steering is generally due to damage to the kingpin and bushing, or damage to the column thrust bearing. When encountering this situation, you can turn left and right to locate the source of the noise for disassembly and inspection. Steering gear oil leakage: The locations of steering gear oil leakage are generally at the steering gear upper cover, the connection between the steering shaft arm, and the side end cover. This is usually caused by prolonged use of the car leading to sealing issues. Difficulty in returning to the original position: Generally, vehicles have an automatic return function for steering. If you need to apply the same force when returning as when steering, it indicates a malfunction in the return function.

16

5

Share

Will a Broken Transmission Pan Damage the Transmission?

What Causes the Abnormal Noise When Raising and Lowering Mercedes-Benz Windows?

Why does the Pajero's side slip light come on and experience weak acceleration?

Can a Rear Air Vent Be Installed in the New Cruze?

Does replacing a BMW electric water pump require matching?

What are the length, width, and height of the Mercedes-Benz 450?

What's wrong with the Audi A6 indicating steering failure?

What does it mean when the EPS light comes on in a car?

What are the reasons for the Chery Fengyun 2 stalling after starting?

What causes gear shifting jerks in Haval H2 automatic transmission?

Why is Emgrand called Geely Merrie?