Will 4S shops cheat in car repairs?

Do family cars require two inspections per year after 10 years?

Family cars require one inspection per year after 10 years, and inspections every six months after exceeding 15 years. Regulations on vehicle inspections: For newly purchased vehicles within 6 years, they are exempt from physical inspection twice (inspection marks need to be applied for every two years without requiring the vehicle to undergo on-site testing); At the 6th and 8th years, the vehicle must undergo on-site testing. For private vehicles over 10 years old, the original inspection cycle still applies: one inspection per year for vehicles aged 10 to 15 years, and inspections every six months for vehicles over 15 years old. Vehicle owners can apply for the inspection mark at the local vehicle management office within three months before the expiration of the current inspection period. About vehicle annual inspection: Vehicle annual inspection refers to a mandatory test for all vehicles that have obtained official license plates and registration certificates. It is equivalent to an annual physical examination for vehicles according to the "Technical Conditions for Motor Vehicle Operation Safety." Vehicle annual inspections can promptly eliminate potential safety hazards, encourage enhanced vehicle maintenance, and reduce the occurrence of traffic accidents.

18

3

Share

What are the differences between Castrol A3 and A3B4 engine oils?

Grades starting with 'A' denote specifications for gasoline engine oils, currently divided into four levels: A1, A2, A3, and A5. Grades starting with 'B' denote specifications for light-duty diesel engines, currently divided into five levels: B1, B2, B3, B4, and B5. Castrol A3: ACEA (Association des Constructeurs Européens d'Automobiles) is the specification set by the European Automobile Manufacturers' Association. The predecessor of ACEA was the Committee of Common Market Automobile Constructors (CCMC), which had similar functions. ACEA revises automotive lubricant specifications every two years, with some standards aligning with API. In the ACEA system, two-character groups are used to classify the quality of engine oils for gasoline and diesel vehicles. Grades starting with 'A' denote specifications for gasoline engine oils, currently divided into four levels: A1, A2, A3, and A5. Castrol A3/B4: A3B4 is the engine oil grade certification by ACEA, the European Automobile Manufacturers' Association, which imposes higher technical requirements compared to API. A3 is equivalent to API's SM grade for semi-synthetic and fully synthetic gasoline engine oils, while B4 indicates that the oil is suitable for both gasoline and diesel engines, with B4 being equivalent to API's CH-4 grade. A3B4 is the engine oil grade certification by ACEA, the European Automobile Manufacturers' Association, which imposes higher technical requirements compared to API. A3 is equivalent to API's SM grade for semi-synthetic and fully synthetic gasoline engine oils, while B4 indicates that the oil is suitable for both gasoline and diesel engines, with B4 being equivalent to API's CH-4 grade.

14

5

Share

What is the general length of a motorcycle?

There are many types of motorcycles, and the body length varies depending on the brand and model. Generally, the length of most common motorcycles is around 2 meters. Larger models may exceed 2 meters, while smaller ones are close to 2 meters. Except for some special, particularly large or small models, most motorcycles are approximately 2 meters in length. Two-wheeled motorcycles: Two-wheeled motorcycles come in two types: off-road and road models. Off-road motorcycles are usually equipped with a single-cylinder gasoline engine, with a cylinder displacement typically ranging from 125 to 400 milliliters. On good roads, they can reach speeds of up to 150 kilometers per hour. These motorcycles are versatile and can be modified for use as off-road racing bikes. Road motorcycles generally feature 2 to 4-cylinder gasoline engines with displacements exceeding 400 milliliters. On highways, these motorcycles can achieve speeds of up to 200 kilometers per hour, making them suitable for long-distance travel. They can also be used as high-speed road racing bikes. Motorcycle types: Motorcycles do not have a standard length; the type of motorcycle is determined by engine displacement rather than body size. Just as the type of driver's license for passenger cars is determined by the number of seats rather than the car's size or engine displacement, motorcycles with an engine displacement of 50cc or less are classified as light motorcycles, while those between 50cc and 250cc (inclusive) are considered large motorcycles. Light motorcycles are not allowed to carry passengers and are limited to single riders, with a maximum capacity of one person. Large motorcycles can carry passengers, with a maximum capacity of two people.

12

1

Share

What are the reasons for the inability to shift into third gear in the transmission?

The reasons for the inability to shift into third gear in the transmission are as follows: Whether the half-shaft is broken: If the car does not move when a gear is engaged, it is a functional comprehensive fault involving the clutch, transmission, and drive axle. During diagnosis, the fault location should be determined first, and the condition of both wheels can be checked initially. The diagnostic sequence generally starts from the drive wheels, moving forward through the rear axle to the drive shaft, then to the transmission, and finally to the clutch. If the drive shaft rotates but the car does not move forward, the fault lies in the rear axle. Lift the rear axle and rotate one rear wheel. If the other rear wheel rotates in the opposite direction but the drive shaft does not follow, it indicates that all rivets of the differential bevel gear are sheared. If the other rear wheel does not rotate, the half-shaft should be disassembled and inspected for breakage. Engaging a gear to start, but the drive shaft does not rotate: If the car is started in a certain gear but the drive shaft does not rotate, the fault lies in the transmission. Remove the transmission cover and inspect whether the transmission shift fork is broken or if the guide block fixing screws are loose. If the above checks are normal, proceed with a gear engagement test. If the second shaft does not rotate in a certain gear, it means the half-round key of that gear is sheared. If the second shaft rotates in direct drive but does not rotate in other gears, it indicates that the support bearings at both ends of the intermediate shaft have collapsed, causing the intermediate shaft to drop. The drive shaft does not rotate in any gear of the transmission: If the drive shaft does not rotate in any gear of the transmission, the fault lies in the clutch. Check whether the clutch is severely slipping, whether all the spline teeth of the driven plate hub are sheared or the steel plate is broken.

10

4

Share

How many labels need to be affixed on a car's windshield?

The front windshield must display three major labels: the motor vehicle inspection compliance label, the compulsory insurance label, and the environmental protection inspection compliance label. Temporary license plates for motor vehicles: Two temporary license plates should be affixed simultaneously. One should be placed in the upper right corner of the front windshield inside the vehicle, in a position that does not obstruct the driver's view, and should not be covered by the compulsory insurance label or other markings. The other should be affixed in the upper left corner of the rear windshield inside the vehicle. For other types of vehicles where installation conditions are limited, only one temporary license plate is required, which should be placed in the lower left or lower right corner of the front windshield inside the vehicle, ensuring it does not obstruct the driver's view for safe driving. Compulsory insurance for motor vehicles: Article 13 of the 'Regulations for the Implementation of the Road Traffic Safety Law' states that the motor vehicle inspection compliance label and insurance label must be affixed in the upper right corner of the front windshield. If a vehicle fails to display these labels as required, traffic police may impose a fine ranging from 20 to 200 yuan. Failure to display the compulsory insurance label as required will result not only in a fine but also in penalty points. Green environmental protection label: According to the draft regulations, if a motor vehicle passes the environmental protection inspection and meets emission standards, the environmental protection department should issue a green environmental protection inspection label as per relevant regulations. If the vehicle does not meet emission standards but is not subject to mandatory retirement, a yellow environmental protection inspection label will be issued. Vehicles that fail to meet emission standards and are subject to mandatory retirement will not be issued any environmental protection inspection label.

16

3

Share

Why does the Cruze engine malfunction indicator light come on?

The engine malfunction indicator light may come on for the following 7 main reasons: Sensor failure: The sensors referred to here include those for coolant temperature, crankshaft position, air flow, intake air temperature, oxygen sensors, etc. When these sensors are damaged, have poor contact, or experience signal interruption, the vehicle's ECU cannot accurately obtain engine data, which can trigger the engine malfunction indicator light. Fuel quality issues: If fuel and engine oil are not added according to the manufacturer's requirements, it may cause engine wear, leading to the malfunction indicator light coming on. Poor combustion of the air-fuel mixture: Poor combustion can lead to engine carbon deposits or knocking. When detected by the oxygen sensor and reported to the ECU, the malfunction indicator light will illuminate as a warning. Issues such as spark plug failure, ignition coil failure, fuel pump failure, or fuel line blockage can all cause poor combustion of the air-fuel mixture. Turbocharging problems: The intake turbocharging pipeline and turbocharger can also cause the engine malfunction indicator light to come on. The most common issue is turbocharger damage, accompanied by symptoms such as oil leaks, excessive oil consumption, reduced power, metallic noises, or blue/black smoke from the exhaust pipe. Intake problems: If there is an issue with the vehicle's intake, it may cause engine pipeline blockage, and in severe cases, trigger the engine malfunction indicator light. A dirty air filter that is not cleaned regularly can lead to intake problems. Exhaust problems: Exhaust system failures can also cause the engine malfunction indicator light to come on. Common causes include issues with the rear oxygen sensor, catalytic converter, exhaust camshaft, and bearing failures, with the catalytic converter being the most frequent culprit. Using leaded gasoline, lead or silicon-based lubricant additives, physical damage to the catalytic converter, or fuel system failures can easily cause catalytic converter issues. Anti-theft system failure: If the vehicle's electronic anti-theft system malfunctions or if the anti-theft controller does not match the engine electronic controller, the anti-theft system can prevent the engine from operating normally, and the engine malfunction indicator light will illuminate. If the engine malfunction indicator light comes on, follow these steps: First, check if the engine is running normally, looking for symptoms such as shaking or black smoke. If present, avoid restarting the engine. Note: Do not restart the engine if the red warning light is on. If the engine can be started, turn it off and wait 5-10 minutes. Without pressing the brake, press the start button once or turn the key halfway to the 'on' position without depressing the clutch. The vehicle will enter self-test mode after powering on. Wait 5-10 seconds to see if the malfunction indicator light turns off. If the light remains on, visit a service center as soon as possible. The service center can use a portable diagnostic tool to read the fault codes, identify the issue, and perform targeted repairs.

3

Share

Will 4S shops cheat in car repairs?

Do family cars require two inspections per year after 10 years?

What are the differences between Castrol A3 and A3B4 engine oils?

What is the general length of a motorcycle?

What are the reasons for the inability to shift into third gear in the transmission?

How many labels need to be affixed on a car's windshield?

Why does the Cruze engine malfunction indicator light come on?

What is required for motorcycle registration?

Is Applying Clear Coat Effective for Headlight Restoration?

What brand is the less-than sign car logo?

Can Small Car Tires Be Replaced with Larger Tires and Rims?