Why Won't the Windshield Wipers Stop?

1 Answers
PrestonLee
07/24/25 11:01am
Windshield wipers are blade structures installed in front of the windshield, consisting of a motor, reducer, four-bar linkage, wiper arm spindle, and wiper blade assembly. Possible reasons why the wipers won't stop include: 1. Blown wiper fuse; 2. Burned-out wiper motor; 3. Faulty wiper switch; 4. Damaged wiper blades; 5. Broken wiper linkage; 6. Wiring issues in the wiper system. Maintenance tips for windshield wipers: 1. Clean water off the wipers and windshield promptly after washing the car; 2. Regularly inspect the wipers for cracks or damage; 3. Stand the wipers upright when parking outdoors for extended periods.
Was this review help?
20
3
Share
More Forum Discussions

How to Apply Gold Plating to a Car?

It can form a sturdy protective layer on the car paint, making it less prone to scratches. It easily integrates with the car paint, allowing for effortless cleaning of all hard-to-clean areas on the paint, leaving the car paint glossy and looking like new. Its coating layer is extremely durable and difficult to wash off, thus providing long-lasting protection for the car paint.
11
3
Share

Is it possible to reverse in a waterlogged section?

Yes, and the possibility of stalling while reversing through water is significantly reduced. Here are the relevant details: 1. Principle: Due to the presence of gas in the exhaust pipe, under normal pressure (water depth of about half a meter), water will not flow backward. Therefore, the key to deep water fording is controlling the speed to avoid splashing water waves from entering the engine compartment. Additionally, the radiator fan should be temporarily turned off before fording to prevent splashed dirty water from damaging the electrical system. 2. Specific situation: After exiting the waterlogged area, the brake pedal should be lightly pressed continuously to remove residual water from the brake system and restore braking performance. If you are really unsure, you can engage the R gear to reverse through the water, which is highly unlikely to cause the engine to stall. Even if you rev the engine hard and then release the throttle, the engine remains stable with no signs of water flowing backward.
3
1
Share

How to turn off the hazard lights flashing on both sides?

When turning the steering wheel back to center during driving, the turn signal will automatically turn off. However, with the development of automotive technology, many modern cars now feature a 'one-touch three-flash' quick turn signal function on the hazard light switch. By lightly 'tapping' the turn signal lever, the turn signal will flash three times and then automatically turn off.
8
0
Share

What is the method for resetting the tire pressure on the Baojun e200?

Before resetting the tire pressure, first check the tire pressure condition of the car to determine whether the tire pressure is normal. The automatic tire pressure adjustment function can automatically correct and reset the tire pressure. After confirming the car's tire pressure condition, you can go to a car service shop to check the tire pressure sensors and clear the corresponding fault codes.
11
5
Share

How many one-inch photos are required for a driver's license renewal?

Renewing a C1 driver's license requires eight 1-inch photos. According to the "Road Traffic Safety Law of the People's Republic of China," the photo size requirement for applying for a motor vehicle driver's license is a 1-inch bareheaded photo of the applicant. In addition to the photos, the following materials are also required for the driver's license application: 1. "Motor Vehicle Driver's License Application Form." 2. "Motor Vehicle Driver's Physical Condition Certificate" issued by a medical institution at or above the county level or the regimental level of the military. 3. The original and a copy of the applicant's valid identity document. Additional information: Below are the photo requirements for applying for a driver's license: 1. Time: The photo must be taken within six months before the applicant applies for the driver's license. 2. Attire: The photo must be a straight-edged, front-facing, bareheaded, color, single-person half-length ID photo without a hat, scarf, uniform, or colored glasses; long-haired individuals should expose both ears, and the head and face should not have any tilting, turning, heavy makeup, or accessories that affect facial feature recognition. 3. Background: The background color should be white, with a clear, well-defined, and natural-looking portrait without obvious distortion. 4. Size: The photo size should be 32mm × 22mm, with a head width of 14mm to 16mm and a head length of 19mm to 22mm.
4
3
Share

How to Use the Blue Bike?

Software to find a bike, book a nearby e-bike in advance. Navigation guides you to the bike, and the bike rings to help locate it when you are close. Scan the QR code on the bike to unlock and start using it. Check your current location, usage duration, and cost. Park the bike in the designated public e-bike area, and it will be automatically returned when locked.
15
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.