Why won't the Cadillac XT5 trunk open/close automatically?

1 Answers
StOlive
07/29/25 8:56pm
The reasons why the Cadillac XT5 trunk won't open are as follows: 1. Linkage rod or lock cylinder issue: If you frequently use the key to open the trunk, the linkage rod may be broken. Go to a repair shop to have it opened. If you always use the remote control to open the trunk, the lock cylinder may be dirty or rusty. Spray some rust remover into the lock cylinder a few times to open it. 2. Not unlocked: The trunk is difficult to open because it hasn't been unlocked with the remote key. Before opening, it's best to press the unlock button on the key or check if the key battery is dead. 3. Mechanical component failure: The trunk itself may have a problem, such as a broken wire or other issues causing the trunk not to open.
Was this review help?
3
2
Share
More Forum Discussions

Can a vehicle still be inspected after being overdue for inspection for more than two years?

A vehicle that has been overdue for inspection for two years can still undergo inspection. When inspecting the vehicle, you need to provide the vehicle registration certificate, compulsory traffic accident liability insurance certificate, vehicle and vessel tax payment or tax exemption certificate, and motor vehicle safety technical inspection certificate. Below are the relevant details: Relevant regulations: According to Article 49 of the "Motor Vehicle Registration Regulations," the owner of a motor vehicle can apply for an inspection compliance mark at the vehicle management office of the registration location within three months before the expiration of the motor vehicle inspection validity period. Before applying: Before applying, the owner of the motor vehicle must resolve all traffic safety violations and accidents related to the vehicle. When applying, the owner must fill out an application form and submit the vehicle registration certificate, compulsory traffic accident liability insurance certificate, vehicle and vessel tax payment or tax exemption certificate, and motor vehicle safety technical inspection certificate.
1
1
Share

Should You Swipe Your ID Card or Start the Engine First in Subject Two?

In Subject Two, you should swipe your ID card first before starting the engine. If the staff turns off the car during the test, the candidate needs to start the engine themselves; otherwise, the candidate can directly start the car by adjusting the seat and mirrors, fastening the seat belt, and following the above steps. Preparation before getting into the car for Subject Two: Walk around the vehicle to check if the lights are off and if there are any abnormalities with the tires; Enter the car, adjust the seat and mirrors, and fasten the seat belt; After preparation, swipe your ID card and input your fingerprint as required; Then wait for the test to begin. Correct method to start the car in Subject Two: Check if the gear lever is in neutral; Start the engine, press the clutch with your left foot, shift into first gear, and press the brake with your right foot simultaneously; Turn on the left turn signal, honk the horn, and release the handbrake; Slowly lift the clutch with your left foot until you feel the car start to vibrate, then stop lifting; Gradually release the foot brake, and once the car starts moving forward, you can completely release it; At this point, keep your left foot at the semi-engaged position, and the Subject Two start is successful.
19
4
Share

How often should the brake fluid be replaced for a Corolla?

There is no fixed replacement interval for the brake fluid in a Corolla; it should be replaced immediately when the water content reaches 3%. The methods and reasons for determining when to replace the brake fluid are as follows: Methods for determining when to replace the brake fluid: During maintenance, you can ask a technician to test the water content of the brake fluid using professional equipment. A green light on the tester indicates a water content of 0.1-1%; a yellow light indicates 1.5-2.5%; the first red light indicates 3%; the second red light indicates more than 4%. If the tester shows a red light, the brake fluid needs to be replaced. Reasons for replacing the brake fluid: The brake fluid needs to be replaced periodically because over time, it can become contaminated with impurities and moisture, leading to deterioration. Deteriorated brake fluid can weaken braking performance or cause a loss of braking effectiveness.
5
0
Share

What does the sport mode of a car mean?

Sport mode in a car refers to the vehicle obtaining stronger power output by increasing fuel injection and lowering the shift timing, delaying upshifts to allow the vehicle to achieve greater acceleration and faster speed increase. The appropriate occasions and precautions for using sport mode are as follows: Occasions for using sport mode: The sport mode of a car is abbreviated as the S gear, and it can be activated simply by pressing the sport button in the car. Sport mode is very convenient to use and is typically applied when climbing hills or quickly overtaking. Precautions for using sport mode: Sport mode should not be used frequently. High RPMs often occur in sport mode, and since fuel injection increases at high RPMs, fuel consumption is much higher than in normal mode. Sport mode only delays upshifts without changing other operational aspects, which inevitably increases the transmission's load, raises its temperature, and accelerates wear in a short period.
14
3
Share

Where is the air conditioning filter of Volkswagen Bora located?

Volkswagen Bora's air conditioning filter is located inside the glove compartment on the passenger side. Open the engine hood, remove the 4 screws on the baffle, and lift the baffle to see the air conditioning filter of Volkswagen Bora. The location of Volkswagen Bora's air conditioning filter is as follows: 1. There is a black plastic plate on the upper part of the passenger footwell, with two retractable clips. Remove the plate by pulling these clips. 2. Disconnect the negative terminal of the battery, then remove the body computer and its mounting bracket (two 12mm screw nuts). 3. Remove the panel on the left side of the passenger's left foot, which has four screws. After removing it, you can see the air conditioning filter of Volkswagen Bora.
14
0
Share

What are the differences between the imported BMW 5 Series and the Brilliance BMW 5 Series?

The biggest difference between the imported BMW 5 Series and the Brilliance BMW 5 Series is that the Brilliance BMW 5 Series has a lengthened body and wheelbase. The differences between the imported BMW 5 Series and the Brilliance BMW 5 Series are as follows: 1. The wheelbase is extended, providing larger rear seating space, and the car's configuration is also enhanced. The imported BMW and Brilliance BMW can be distinguished by the badges at the rear—the Brilliance BMW has the words 'Brilliance BMW' on its rear. 2. The Brilliance BMW has a slightly higher chassis, while the imported BMW's chassis is slightly lower, as the imported BMW leans towards a sportier design with a more dynamic feel. 3. In terms of interior, the Brilliance BMW offers only one option, whereas the imported BMW provides two choices to cater to more preferences. Both models share the same powertrain, equipped with a 2.0T turbocharged engine, but there are differences in engine components. The engine of the imported BMW 5 Series is entirely imported from Germany, while many parts of the Brilliance BMW 5 Series's engine are processed and procured domestically. Compared to the imported BMW, the Brilliance BMW shows some performance differences.
15
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.