Why should you turn on the turn signal when stopping and starting on a slope?

1 Answers
HazelMarie
07/29/25 12:36pm
You should turn on the left turn signal. The turn signal is not for your own indication but to inform other vehicles or pedestrians. Slow start: When starting on a slope, slowly release the clutch pedal with your left foot until the vehicle begins to vibrate. Hold this position slightly to confirm whether the vehicle has the tendency and power to move forward. Do not continue to lift the clutch pedal to prevent stalling. Slowly accelerate: When the vehicle starts to move forward, the right hand can completely release the handbrake, and then slowly accelerate. When starting on a slope, if you do not give it gas, it is likely to stall due to insufficient idle speed, which cannot drive the vehicle to start on the slope.
Was this review help?
9
5
Share
More Forum Discussions

What to Do If the Audi A6L 2.4 Has Severe Oil Burning Issues?

Audi A6L 2.4 has severe oil burning issues. If it is not due to oil leakage, then it is likely caused by the following two situations: 1. The valve stem seals are aged and have poor sealing, leading to oil consumption. 2. The cylinder is worn, and the piston rings have poor sealing, resulting in oil consumption. Here is an introduction to the Audi A6L: 1. The Audi A6L is equipped with a third-generation 1.8TFSI engine. TFSI stands for a turbocharged FSI engine, which further enhances performance and efficiency, delivering a maximum torque of 320Nm and powerful performance. 2. The Audi A6L is a domestically produced high-end luxury business sedan introduced by FAW-Volkswagen, featuring the most advanced technology, optimal performance, and strong adaptability to local conditions. 3. The Audi A6L's multitronic continuously variable transmission (CVT) is the first in luxury car history to achieve true seamless gear shifting.
12
3
Share

Should the Civic's AC be set to ON or OFF for cooling?

The Civic's air conditioning cooling should be set to ON. The method to operate the Civic's air conditioning is as follows: 1. Power on: Press the brake pedal of the Civic. Press the one-touch start button located on the right side of the steering wheel. The car dashboard will light up, and the vehicle's power will be fully activated. 2. Turn on the air conditioning: Rotate the fan speed knob to activate the air conditioning system. Turning the temperature knob to the left sets it to cooling mode, while turning it to the right sets it to heating mode. Additional information: The car air conditioning system creates optimal working conditions for the driver and serves as a crucial ventilation device for ensuring safe driving. It generally includes a cooling device, heating device, and ventilation system.
1
2
Share

Which country is Jaguar from

The cruise control icon is a circle with markings inside and an arrow in the upper left corner. The main buttons of the cruise control system include: the power button (ON/OFF), the cancel button (CANCEL), the set current speed button (SET), the resume set speed button (RES), the accelerate button (+) which is usually combined with the RES button, and the decelerate button (-) which is combined with the SET button. The specific usage method is as follows: 1. Press the power button to turn on the system, at which point the cruise control indicator light on the dashboard will illuminate. 2. Accelerate to the desired speed and press the SET button. At this point, you can release the accelerator with your right foot, and the speed will be set at the current speed. 3. Press RES+ to increase the speed from the current speed, and press SET- to decrease the speed from the current speed. 4. There are three ways to deactivate cruise control: pressing the brake, pressing the cancel (CANCEL) button, or pressing the power (ON/OFF) button. 5. If cruise control is canceled by pressing the brake or the cancel button, pressing the RES button can restore the original cruise control speed.
15
5
Share

Can a spare tire be used on the highway?

Spare tires can be used on the highway. The details of various spare tires are as follows: 1. Full-size spare tires have no restrictions on mileage or speed and can replace any tire that is temporarily or permanently unusable. 2. Non-full-size spare tires can only be used on non-driving wheels, and the maximum speed should not exceed 80km/h. This is because the diameter and width of such spare tires are slightly smaller than the other four tires, making them suitable only for temporary replacement. 3. Run-flat tires (commonly known as "anti-blowout tires") do not lose air or lose air very slowly when punctured. They can maintain their driving profile, and the tire bead remains fixed on the rim, ensuring the car can drive to a service station for a long time or temporarily stable.
15
0
Share

Can Radiator Coolant and Antifreeze Be Mixed?

Radiator coolant and antifreeze can be mixed, as radiator coolant is essentially an improved version of antifreeze. How to determine if antifreeze is low: Observe the antifreeze warning light on the dashboard. If it lights up, it is likely due to low antifreeze levels, though it could also be caused by excessively high engine temperatures. Check the antifreeze reservoir. If the fluid level is below the minimum mark (MIN), do not continue driving and promptly add antifreeze. Inspect the water level indicators on the antifreeze tank. The normal antifreeze level should be between the maximum and minimum marks. If it falls below the minimum mark, it indicates a shortage of antifreeze. Antifreeze replacement cycle: For vehicles that operate for extended periods, such as taxis, high-quality antifreeze should generally be replaced annually. For vehicles with shorter operating hours, replacement can be done every two years or every 30,000 kilometers. To prevent excessive foam formation, which reduces the heat exchange efficiency between the antifreeze and engine components, ensure the product is within its validity period when adding. Long-life antifreeze can remain effective for up to three years. If suspended particles, sediments, or signs of deterioration or discoloration are observed in the antifreeze, replace it immediately and clean the system.
7
4
Share

How to Interpret the P0700 Trouble Code?

P0700 trouble code, applicable to all car manufacturers, means Transmission Control System Malfunction (MIL Request). Solution: The appearance of this trouble code indicates a problem with the transmission. If there is an issue with the transmission, it is recommended to promptly visit a 4S shop for inspection and repair. Additional Information: 1. The Transmission Control Module (TCM or TCU) helps the transmission decide when and how to shift gears by collecting information from various sensors and the Engine Control Module, thereby improving vehicle performance, ensuring smooth gear shifts, and saving fuel consumption. 2. The Malfunction Indicator Lamp (MIL), also known as the Check Engine Light, illuminates a yellow or red engine symbol on the dashboard when the control module detects a fault. This trouble code indicates that the Powertrain Control Module (ECU) has received a request from the Transmission Control System (TCU) to illuminate the Malfunction Indicator Lamp.
18
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.